You shouldn't even think of doing that. Just replace the switch.
GO BUY A NEW IGNITION SWITCH AND KEY SET TO INSTALL IN THE COLUMN. It's not that simple smart#@$! If anyone can answer the question intelligently I would appreciate it.
1993 Volvo 850 : Where would a cold start injector be located - only see 5 injectors. ... 1995 Chevrolet Lumina : 1995 Chevy lumina van. motor dies at low speeds. more ... 1992 Ford Explorer : what would cause high oil pressure blow by on my 92 ... Thanks for your hard work, and impressive contributions to this ...
no, it will spin free if the timing belt breaks
I know that you have to put the truck in base timing mode for my 93' but I have a EST or HEI style ignition. If you have the electronic distributor then find the grey wire with a plug on the end of it next to the A/C box on the left side under the hood near the firewall. It will be hanging out of the wire harness. Apply 12 volts to it from your battery with a jumper wire and the truck will go into base timing mode. then line up the marks on your balancer. take the jumper wire out and your set.
It will take an experience mechanic approximately 8 hours to replace the timing belt in your 1992 Chevy Corsica. The 1992 Chevy Corsica does not have each timing chain, it has a timing belt.
How do you convert the ac in a 1992 Chevy lumina
number1 piston up timing marks align with each other
2.5-chain 3.1-chain 3.4-Both chain and belt (ain't that be-you-tee-fal?)
Hopefully you mean a 1992 Lumina, and yes, most starters are standard.
there is no alternator on the 1992 Lumina its all electric, so there is no need for one.
The Chevy lumina does not have an inertia switch.
Remove the belt from your 1992 Chevy Lumina water pump. Remove the water pump return hose. Remove the water pump retaining bolts. Reverse the process to install your water pump.
Yes it will, I did the interchange on mine
under the engine
ype your answer here...
Remove the positive cable from your 1992 Chevy Lumina battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.