In my 86-96 aerostar repair manual it says to use new bolts , tighten the bolts over a 3 step sequence to the torque required. Here is the sequence
5 1 3 7
6 4 2 8
Step 1 44lbs step 2 tighten intake mainifold to 36 -72 in lbs step 3 59lbs step 4 tighten intake manifold to 72 to 132lbs in-lbs step 5 turn cylinder head bolts an additional 80 to 85 degrees
step 5 complet intake mailfold torque steps 3 and 4
i copied it word for word
Tightening the bolts in the typical order from the middle out, the upper intake bolts torque in first pass at 44 in lbs, the second pass at 88 in lbs. The lower intake bolts start with 27 in lbsfor the first pass, 106 in lbs for the second pass and 133 in lbs for the last pass.
The 1996 Ford Escort 1.9 liter engine cylinder head bolt torque specification is 120 pounds. The head bolts should be torqued in 40 pound intervals.
Tighten the bolts to 60 nM (44 ft. lbs.) in sequence. Tighten the bolts to 60 nM (44 ft. lbs.) in sequence.
For what? Without knowing, I will give you the head bolt specs. First, always use new bolts. Begin in the middle. Then go to the ends. Never tighten two bolts on the same side in sequence.. First torque them to 22ftlbs, the go around and do them again give them 1/4 turn. 90 degrees. Then do that AGAIN, go around the sequence a third time and give them another 1/4 turn. Toyota provides no specifications for the final ftlbs of torque.
Torque specs for 2006 F-150 (2 wheel drive) spindle nut is 295 ft lbs. This is according to Ford's specs.
Torque specs for main bearing
wich bolts do you need the specs on
A C15 Caterpillar engine has dozens of torque specifications for many different engine bolts. The head bolts should be torqued at 350 pounds.
For the head bolts, 37lbs
There are a lot of bolts on the engine and we don't know what bolts your talking about, there are different torque specs all over the engine, I would say that you should go to the library and get a chiltons repair manual for your car and it will tell you the specs your looking for.
What is the torque specs for Head bolts for 2003 Johnson 4 stroke 140 hp outboard boat engine
For the 1996 Chevy S-10 4.3 liter, the torque specs for the crankshaft damper bolts is 70 ft. lbs. For the cylinder head bolts, the torque is 65 ft. lbs, and for the engine mount-to-head bolts, the torque is 35 ft. lbs. For the engine mount-to-frame bolts, the torque is 52 ft. lbs.
torque especifications for Malibu 1999 3.1 engine
Torque specs for a 1995 subaru impreza 2.2 head bolts?
what torque specs on cam shaft bolts 2000 saturn 2.2
The torque specs for 660 raptor head and hex bolts is about 26 lbs.