0
What is the coolant capacity of a 1989 Ford F-250 with a 302 engine?
Wiki User
∙ 13y ago
4 qts for the radiator alone.
If the entire system is drained (block, heater, radiator) it would take 12 to 14 quarts.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Where is the starter solenoid on a 1989 F250?
starter solenoid is on the inside of the fender twards the cab from the battery follow the positive battery cable at the end will be the solenoid
1976 Ford F 250 4 X 4 with a 390 4 barrel. Will a 428 or 427 bolt in to the same bell housing and engine mounts?
Yes. The 352, 360, 390, 406, 410, 427, and 428 are all FE's and are based on the same engine block. I have a 76 F250 4x4 highboy with a 390 and my brother has one with a 428. The engine mounts are the same and the 428(also 427) will bolt directly to your transmission (NP435 or C6). If you have or are building a 428, remember this engine is externally balanced (the 390 is internally balanced) so the flywheel (if manual trans flexplate if auto) needs to be balanced with the rotating assembly.
1993 F250 idles too high?
I Would say the choke on your one barrel carburetor is sticking Start the engine. Let the engine reach operating temperature.Remove your Air cleaner to your Carburetor while the engine is running.Look down the throat of the carburetor and you will see a round flap A.K.A the butterfly.This flap should be completely open when the engine is at operating temperature open so that the air can pass through the throat of the carburetor freely. If you don't understand how a choke works go to howstuffworks and ask how a carburetor choke works and it will all make since.
Where and how do you change the glow plugs on a 97 F250 turbo diesel?
the glow plugs are located inside the the valve covers on the engine' the wire harness goes thru the cover gaskets.so this is a major job.if you break a gasket while removing, they cost about $70 , each to replace. you also need special tools to remove glow plugs. it is much easier and safer to take the truck to a reputable diesel mechanic.
What is the distibutor point gap suppose to be set at for 1971 ford 360 ci with four barrel?
If the 360 is in a F100 the point gap is .021. If the 360 is in a F250 or bigger the point gap is .017.
Coolant capacity ford f250 5.4liter engine?
4 gallons
What is the oil capacity of 1989 Ford F250 diesel?
10qts
What is the engine oil capacity for a 2003 ford F250 6.0 liter engine?
It should be the 6.8 liter engine and the capacity is 6 quarts
Where is the engine coolant temp sensor located on a 1992 ford f250?
what engine? most will be close to the t-stat.
What is the antifreeze capacity for a 1997 F250 with a 7.5 liter engine?
6.0 gallons
What is the oil capacity on a 2004 F250 Super Duty?
That depends on which engine is in it. If it is the 6.0 Powerstroke diesel, the oil capacity is 15 quarts.
1989 Ford F-250 engine wiring diagram?
i have to change oil pump f250 351winsar.how topull the engine out?
Where is the coolant temp sensor on your 1992 ford F250 with a 5.8L?
The 1992 Ford F2 50 pickup truck 5.8 liter engine coolant temperature sensor can be found on the top of the engine. The coolant temperature sensor will be near the intake manifold.
How many quarts of oil needed for oil change for 1999 ford f250?
If you are referring to the diesel engine, its capacity is 15 quarts, but if you are referring to the gasoline engine, the capacity is 6 quarts.
Gas mileage for 1989 Ford F250 7.5l 460?
i have the same engine in a 1984 e350 and i get about 8
What is the engine oil capacity for a 2004 ford F250 6.0 liter engine?
'03 6.0 takes 15 quarts. '04 should be the same.
Why won't your 1989 Ford F250 with 5.8 L engine idle?
sounds like a bad idle control sensor
