If I understand your question........the rear license plate lights on 2005 C240 have a clear cover with 2 Phillips head screws. Just take out screws to replace bulb. (easier if trunk lid is completely open).
To change the rear number plate on a Mercedes C180 Classic, start by locating the screws or clips holding the plate in place, usually found at the top or sides. Remove these fasteners using a screwdriver or appropriate tool. Carefully take off the old plate, clean the area if necessary, and then position the new plate before securing it with the screws or clips. Ensure the plate is properly aligned and firmly attached for safety.
in the armrest thing, at the back
Undo the screws around the number plate, take the number plate off then put the new number plate on.
How do you change the number plate bulb on mercede E220 2001?
from inside the trunk pop all of the plastic rivots and you can access the bulbs from the inside..
I had that same problem this week with my 2001 ML 430 due to a change of battery. I called the main or official Mercedes Benz dealer even though I did not purchase my ML there and they provided me the code immediately. The only asked for my name, license plate and VIN number. Hope this helps!
You need to open the hood and locate the radiator behind the vehicle's grill. Next, look on top of the radiator for a metal data plate. The data plate lists the engine number.
No there will be additional charge for getting your license plate changed
To change your license plate number, you will need to visit your local Department of Motor Vehicles (DMV) office and request a replacement plate. You may need to fill out a form and pay a fee to receive a new license plate number. Make sure to bring your current registration and identification with you when you go to the DMV.
They are located inside the trunk lid, underneath the felt lining. You need to unsnap and pull back the felt lining to access the bulbs for the license plate light.
They are located inside the trunk lid, underneath the felt lining. You need to unsnap and pull back the felt lining to access the bulbs for the license plate light.
Without exact model I can't check exactly but see sources and related links below for an easy place to try.