answersLogoWhite

0

No parts available. Makes a door stop

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Tune up 2003 echo?

The Toyota echo does not have wires or a rotor, each spark plug has its own ignition coil (coil pack). So really, all you can do is change the spark plugs.


Why does your third cylinder partially fire in a 2002 Toyota Echo--you have replaced the ignition coil and injector already?

See related link.


What is the difference between a magneto and a coil?

An ignition coil requires external electrical power. A magneto requires only mechanical power to create an ignition spark. If an engine HAS no electrical power (lawnmower, tiller, chain saw) then a coil would not function.


Where is the ignition coil on a 96 civic cx hatchback?

The ignition coil is inside the ignition distributor.


Is an ignition module the same as a ignition coil?

No. The coil provides the spark and the module tells the coil when to spark.


Where is the ignition coil located in a 1998 tercel?

The 1998 Toyota ignition coil is located on the firewall, in the engine compartment. The ignition coil can be found on the passenger side of the firewall.


What if your ignition coil keeps blowing-- i have replaced it twice and replaced the injector --i have been told its the ecu--what is in between the ignition coil and the ecu in a 2002 Toyota Echo?

Wire , lots and lots of wiring , but you need to be more specific , a Echo uses 4 coils , 1 for each cylinder , and being a mechanic myself at a Toyota dealership , this is rare. Make sure your not having condensation problems , ex water around the coils , as this will cause arcing and it will look like the coil is not delivering its spark.


How do you replace a coil on 2003 Chevrolet Express?

REMOVAL PROCEDURE Remove the engine cover. Disconnect the spark plug wires at the ignition coils. Disconnect the ignition coil harness connector. Remove the ignition coil mounting bolts. Remove the ignition coil. INSTALLATION PROCEDURE Install the ignition coil to the bracket. Install the ignition coil mounting bolts. NOTE: Refer to Fastener Notice in Service Precautions. Tighten Tighten the ignition coil mounting bolts to 8 N.m (71 lb in) . Connect the ignition coil harness connector. Connect the spark plug wires at the ignition coils. Install the engine cover.


How do you test ignition coil on your Alero 1999?

1999 Alero how do i test ignition coil pack


Where is ignition coil located on 1996 Volkswagen?

Where all the wires plug into. That is the ignition coil. The ignition coil is inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil.


I have replaced everything involved in my ignition system but still lose spark after driving for a short period of time if you le tit sit for an hour it will restart again any suggestions?

did you have your ignition coil replaced? the signs are that the ignition coil is overheating thus you are able to restart after an hour, when the coil cools. also check if your ignition coil has a resistor. if it has, have it checked for continuity. did you have your ignition coil replaced? the signs are that the ignition coil is overheating thus you are able to restart after an hour, when the coil cools. also check if your ignition coil has a resistor. if it has, have it checked for continuity.


Where is the ignition module on a Chevy Caprice ls?

Its right above the ignition coil. Infact you have to remove it first to remove the ignition coil.