0
Is there a way to adjust the timing belt on a 1995 Mazda 626 instead of replacing it?
There is no manual adjustment for those overhead cam engines. They use those things called tensioner and idler. If it has about 100,000 miles or so it would better to replace the belt, tensioner, idler, and water pump all at once. Cause if you dont and just replaced the belt only then later the water pump can go bad then you will have to take everything all apart again. The belt can usally last about 100,000 mile before needing replacement. If you are going to replace the belt you will need a tool that will hold the overhead cams before you remove the belt cause the cams can shift (turn) when the belt is removed due to pressure from the valve springs.
What else can I help you with?
Does a 2004 Mazda MPV 3.0 V6 have a timing chain or a timing belt?
as an owner of an lx, i have a timing chain which doesn't need replacing
How do you set up timing marks on Mazda B2500?
adjust the timing to the correct spot then make a mark on the distributer
How can you fix timing chain of Mazda 6 2004 2.3L engine?
You fix it by replacing it.
Why does a 1998 Mazda 626 engine rev when in park?
I had the same issue with a 1990 Mazda 626 and replacing the timing belt cured it.
1995 Mazda miata 1.8L replacing timing belt?
http://www.miata.net/garage/timingbelt.htmlTry this.
When to change timing belt on 2000 Mazda 626?
The timing belt on a 2002 Mazda 626 should be changed every 100,000 miles. By replacing it before it completely fails, costs repairs can be avoided.
Does a Mazda b3000 have a timing chain or a timing belt?
Yes I believe it is a timing chain as i am replacing mine tonite and it was cheap 73.00 Canadian don't forget gasket set
How do you adjust ignition timing 1998 Mazda distributorless 2Litre?
ignition timing is controlled by the electronic control module or the "brain" on distributorless engines. Reysher
How do you tension timing belt on Mazda 1.8 dohc engine?
You don't. The timing belt should have a spring loaded tensioner which pulls on the belt to adjust tension.
Mazda mpv 1995 stalling while up hill why?
there is a good chance your timing is out or your fuel filter needs replacing
How do you replace the water pump on a 1992 - 1996 Mazda 929?
Hi Its located under the timing belt cover......better plan on replacing the timing bet too
How do you adjust the timing on a 98 Mazda 626?
To adjust the timing on a 1998 Mazda 626, first, ensure the engine is at operating temperature and then disconnect the timing connector to enter the base timing mode. Use a timing light to check the timing marks on the crankshaft pulley against the specifications found in the service manual. If adjustments are needed, loosen the distributor hold-down bolt and rotate the distributor until the desired timing is achieved, then retighten the bolt and reconnect the timing connector. Always recheck the timing after adjustments to ensure accuracy.
