What specs do you need? Torque for the gears or caps? Dimensions? TDC timing marks?
Yes, the size 38W x 34L and XL are considered a size. 38W is the waistline and 34L is the length. XL stands for extra large.
the plug gap is 0.60. hope this helps...
The location for the O2 sensor(s) are on the exhaust manifold in front(before catalyst, catalytic converter) for checking emissions from combustion chamber or behind (after catalyst) for analyzing emissions from the catalytic converter.
The horse power is 175
195 fp n 205 for gt
take it to a Toyota dealership, have them run the code through the scan tool and reset the light as necessaryAnswerYou could, if you want to waste your money. All you have to do is disconnect the negative cable from your battery, wait a minute and reconnect it. This resets your computer. Also, you can buy a cheap code reader for around $50 instead of paying around $80 to get it done at the dealership. They are easy to use and plug in usually under your steering wheel or under the seat. They are useful for finding whats wrong but wont tell you great details like the expensive ones do.
Actually, I had a 97 Beretta engine put into my 95 Lumina and it was fine.
That's the waist and the inside leg measurement in inches.
it is located right underneath the throttle body just look down there and youll see it :)
Use a code scanner to check the engine diagnostic codes. If you see any problems fix that first. If there are no issues, check fuel pressure at the fuel rail test port. If the fuel pressure is low either at an idle or when driving under full power, check and/or replace the fuel filter.
Answer: 68 L NO22NO + O2 ------> 2NO2>68 L + 34 L --> 68 L + some 'left over' NO
clean iac sensor and o ring