0
Add your answer:
Earn +20 pts
Where is the ignition module on a 1996 stratus?
The engine computer is the ignition module.
Is there a distributor - ignition control module on 1996 or newer Taurus - Sables?
AnswerSince 1996, engine ignition control has been handled by the Powertrain Control Module (PCM).The PCM has direct control over the ignition coils / coilpack (or coil-on-plug on some engines) - so the need for a 'distributor' has gone away.Coilpacks cost about $75Sidebar: without a distributor, the engine timing is also totally handled by the PCM.See "Related Questions" below for information about Ignition Control Modules on 1986-1995 Taurus/Sables.On a 1996 Ford Taurus the ignition control module is part of the drivetrain control module. To change the ignition control module you have to change out the computer. It is located behind the motor on the passenger side of the engine compartment. Look for a screw holding in a wiring plug with a dozen or so wires. The drivetrain control module has a couple of nuts holding it in place and looks like a cdrom when removed. Good luck. John
How do you change the ignition control module on 1996 mercury cougar xr7?
there is no ignition control module on the 1996 model its all through the PCM
Routing diagram the serpentine belt on a 1996 v6 3.0 Ford Taurus?
Click the link for a diagram.
Where is the ignition control module on an 1996 mercury mystique located?
na/
Where is the ignition control module located on a 1996 dodge neon?
Autozone
How do you remove an ignition switch on a 1996 Ford Taurus GL?
I have a 96 Ford Taurus and need to get the key switch out. Please help.
How do you change an ignition module on a 1996 LSS?
Remove the 3 coils which are help on by 2 5.5 mm bolts each. The module is now free. Remove electrical connector from ignition module. - Tech JK -----------------------------------
Were is the electronic ignition module at on your 1996 Chevy s10 truck?
If this is the 4.3 engine, it is located on the bracket next to the ignition coil.
Can a 1996 Ford Taurus replacement ignition lock cylinder be fitted to the original key?
Yes it can
Where is the ignition module on a 1993 Ford Taurus located?
On the bottom side of the engine( front of the car) just below the exhause manifold. It is easiest to remove the mounting plate from the body of the engine, as balancing the coils on the module as you remove and insert screws if a real pain in the but. If anyone has any suggestions on waterproofing this area, I would greatly appreciate it, as I have gone through three of these modules in three years due to water getting into it and shorting the module out. This last time it was a coolant leak around a seal on the top of the water pump, spraying right into the module that caused it. Argh!
Where is the ignition module on 1996 Buick Century located?
The ignition module is located under the three ignition coils. The same bolts that hold the coils in place also retain the module to the mounting bracket. To find the coils, follow the ignition wires from the front of the engine to where they attach at the rear. The wires clip to the coils.
