Sienna's have two knock sensors located in the valley underneath the intake manifold. Replacement is a three hour job.
On a 2000 Toyota Sienna, the knock sensor is typically located on the engine block, beneath the intake manifold. To access it, you may need to remove the intake manifold, as it is situated on the side of the engine. It's important to consult a repair manual for specific instructions and diagrams for your model.
The manufacturer states throttle body and the intake manifold must be removed to access the knock sensor. The knock sensor is located on side of cylinder block.
If you have the 7MGE engine: Then the knock sensor is screwed into the engine block, directly underneath the intake manifold.
The knock sensor on a 2001 Toyota Sienna is typically located on the engine block. Specifically, it can be found on the passenger side, near the rear of the engine, beneath the intake manifold. You may need to remove some components for better access, so consult a repair manual for detailed instructions.
Trouble code P0325 means: Knock Sensor 1 Circuit (Bank 1) Trouble code P0330 means: Knock Sensor 2 Circuit (Bank 2) Need to replace Knock sensor
where is the knock sensor on a 95 Toyota t100 v6
The "knock sensors" for the Avalon 3.0 are facing the firewall on the engine block just below the cylinder head ,their are two knock sensors .
The knock sensor for a 2002 Toyota Sienna is located on the engine block, specifically on the rear side of the engine near the transmission. It is typically mounted near the cylinder head, making it a bit challenging to access. To reach it, you may need to remove some components or the intake manifold for easier access. Always consult a repair manual for your specific vehicle for detailed instructions.
knock sensor location
Location of knock sensor 1991 GM sierra 350 2500?
location right bank knock sensor 2003 5.3 z71
where is the nock sensor on my 95 toyota 4runner