0
How do you determine whether to replace the clutch system or the slave cylinder on a 2002 Ford Ranger 4 cylinder?
have someone MASH the clutch while you are under the truck looking at the cylinder to see if its moving, if no movement undo the line and hold your thumb over it and have someone mash the clutch to see if brake fluid squirts out, if no fluid squirts out, replace the clutch master cylinder
What else can I help you with?
What is the approximate cost to replace a cylinder in a 2003 Ford Ranger?
what sort of cylinder you want to replace?
Can a 6-cylinder ranger transmission fit in to a 4-cylinder ranger?
Several factors are involved with the ability to swap these transmissions. Depending on the Ranger year, the bellhousing and clutch systems can be different sizes, as well as the mounts. With the year of the Ranger and the 6 cylinder transmission then you can determine if the switch is possible.
Does the transmission of a 1994 ford ranger 2.3l have to be removed to replace the slave cylinder?
yes
How do you replace the brake cylinder on a 1996 Ford Ranger?
Master cylinder or drum brake (hydraulic slave) wheel cylinder or disc brake caliper cylinder? drum brake shoes rear
What steps do you take to remove and replace the master clutch cylinder of a 1992 Ford Ranger?
If you need to replace the slave cylinder it is located in the bell housing and the trans has to be removed. The clutch master cylinder is located on the firewall on the drivers side
How do you fix a slave cylinder in a 1993 ford ranger?
you just need to hone it out and replace parts with rebuild kit.
How can you tell whether or not your Ford Ranger is a 4.0 Liter 6 cylinder or a 3.0 Liter 6 cylinder engine?
it should say on the top of the motor in big print.
Should you replace the slave cylinder when you replace the clutch in a 1994 ford ranger?
Not if it is working alright. however if you suspect its the worst for wear it would be a good idea,
Where is the slave cylinder on 1990 Ford Ranger?
It should be around the pilot shaft on the trans. It requires removal of the trans to replace it.
Can a 93 ranger 6 cylinder and transmission fit in a 92 ranger with a 4 cylinder?
Yes.
How do i repair the slave cylinder on my 1988 Ford Ranger?
The slave cylinder on a 1988 Ranger can not be repaired. The cylinder will have to be replaced, then the system bled.
What are the cylinder numbers on a Ford Ranger?
where is the number 3 cylinder located on a 2.5 ford ranger engine
