0
it is easy just find the belt tensioner and put a socket wrench on it and push it down and the belt will be loose just pull of the belt off and then put the new belt on the pulleys the correct eat there should be a diagram on the top of the radiator if it is not there then you need to remember what the belt you took off looked like take picture with your camera phone. If you do not know what a belt tensioner is go to autozone.comand look at the picture then find itbon your engine that's it Good Luck. The belt goes through the front left side motor mount. The mount has to be moved to be able to install belt
What else can I help you with?
How do you install a water pump in a 1997 Oldsmobile aurora?
remove and replace water pump in 1997 Oldsmobile aurora
How do you replace an idler pulley on a 1997 Ford F150 5.4ltr?
Remove serpentine belt. Remove pulley. Install new pulley. Install serpentine belt.
What is the serpentine belt diagram for a 1997 Oldsmobile 88?
I could send a photo - email me at ken.elder@shaw.ca
What is Code p0171 1997 on Oldsmobile regency?
Trouble code P0171 means: Fuel Trim System Lean (Bank 1
Where can you get a diagram of the serpentine belt for a 1997 E420 V8 Mercedes Benz?
i need a digram on how install a v belt on a 1997 e420 Mercedes
Where is the fuel filter on a 1997 Oldsmobile Regency?
On a 1997 Oldsmobile Regency, the fuel filter is located along the fuel line, typically mounted on the underside of the vehicle. It is commonly found near the driver's side, just in front of the rear axle. To access it, you may need to lift the vehicle for better visibility and reach. Always ensure to relieve fuel system pressure before attempting to replace the filter.
Serpentine belt routing for 1997 cavalier?
The drivebelt routing decal on the radiator shroud to help during drivebelt install
Where can you find a schematic for the serpentine belt for 1997 Oldsmobile Aurora?
on a fancy little drawing under the hood usually on or around the drivers side strut tower
How do you change a crankshaft position sensor in a 1997 Oldsmobile Regency?
1. remove positive battery cable. 2. Remove the serpentine belt. 3. remove harmonic balancer. 4. remove timing cover. 5. remove wiring connector from c.p. senser. 6. remove c.p. senser. 7. reassemble in same order as disassembled.
How do you replace the serpentine belt in 1997 grand am?
How do you replace the serpentine belt in 1997 sunfire
Why would the AC in an 1997 Oldsmobile Regency only blow air out of the floor and defrost vents?
on my 1992 road touring itdid the same thing and it was the computer but it only cost 102.00 from gm
Does a 1997 Regency powered seat go back further than a 1998 Regency powered seat?
No.
