answersLogoWhite

0

If the coil is behind the intake, it is easiest to remove wiper arms and cowl below windshield. At least you will be able to see the ignition coil. After that have fun.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Replacing the ignition lock cylinder on 2000 Cadillac Catera?

how do you get ignition switch out of steering column in 2000 catera?


How do you replace the speed sensor on 2000 Cadillac Catera?

How do you replace the speed senor on a 2001 cadillac catera


Diagram of 1999 catera spark plug replacement?

How do I replace the spark plugs in a 1999 Cadillac Catera?


How do you change valve cover gaskets on a 01 Cadillac catera?

cadillac catera replace valve cover gasket 1997


Cadillac Catera 97 misfire on cylinders 1st 3rd and 5 why?

Note: Cyls Compresion is perfect, sparks, spark plugs, ignition coil, all is fine You have an ignition coil at rear of plenum. trace wires back to it...it is bad! Replace it and you should be fine!


Where is the 5 cylinder on 2001 Cadillac Catera?

The 5-cylinder engine is not present in the 2001 Cadillac Catera, as it is equipped with a V6 engine. The Catera features a 3.0-liter V6 engine that is located in the front of the vehicle, under the hood. If you're looking for information on a specific component or part of the engine, please clarify!


How do you fix clogged catalytic converter on 1999 catera?

Replace it


Why is it when I replaced my ignition switch in my Cadillac Catera my car just cranks and cranks but will not start?

its not your ignition its your crankshaft sensor that's the same problem i had.


Where do you purchase a 98 catera ignition key?

you have to take it to a dealer.cost about 150.00 they have to program key to the car.


What causes a 1997 Cadillac Catera overheat?

Head Gasket to replace


How to replace 1998 Cadillac Catera valve cover gasgets?

To replace the valve cover gaskets on a 1998 Cadillac Catera, first, ensure the engine is cool and disconnect the battery. Remove any necessary components obstructing access to the valve covers, such as the intake manifold or ignition components. Once the covers are exposed, unscrew and lift them off, then clean the mating surfaces thoroughly. Replace the old gaskets with new ones, reassemble the covers, and reconnect any components you removed.


How difficult is it to replace the power steering pump on a 1997 Cadillac Catera?

fdgf