answersLogoWhite

0

On certain years there was a campaign from Nissan that had the techs replace both at once. Even if the car had no problems. They are the same type sensor. I think it was 95 to 97 if I remember right. So I would.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How often should you change crank sensor?

You only need to change it if it has failed. There is no other reason.


Where is the crank sensor on 2000 kia sportage 4x4?

crank sensor should always be near bottom crank pulley


How do you change crank sensor for a 1998 dodge neon?

there is a bolt off to the right off the sensor take it out and it should just pull right out.


Where is the crank sensor located on a 1999 Saturn SL2 and how do you change it?

The crank sensor is behind the starter. Remover the starter at the back of the engine and you will see the sensor


Where is the crank position sensor located on a tacoma?

Should be by crank pulley.


How do you change the crankshaft position sensor on a 2003 Nissan Altima?

How do you change the crank sensor on a 2002Nissan Atima3.5?


Where is the crank sensor located on 1997 grand prix gt 3.8 liter?

the ckp for the 3.8 is located at the harmonic balancer on all applicatins remove the right side (passenger) tire and also the plastic shroud, you should be able to access the crank sensor from there You'll have to pull your harmonic balancer to change the crank sensor.


How do you change a 2.5 l crank sensor?

very carefully


If your crank sensor goes out how do you know which one to change?

There is only one crank sensor fitted, you may also have a cam sensor. the crank sensor is located either around the bellhousing or around the front crank pulley. It either has 2 or 3 wires. It picks the signal off the revolving crank so look for a sensor in the block near flywheel.


Will 92 park avenue start with bad cam sensor?

No it will not start need to change the cam sensor & crank sensor!


Dies after warm have change pump- module - crank sensor?

What dies?


Where is the crankshaft sensor located on a 5.3 liter Chevrolet engine?

Your crank sensor should be located near the harmonic balancer, most likely just behind the balancer. These sensors are tiny and hard to spot. NEW ANSWER: The crank sensor is behind the starter, and you will need to remove the starter to see it and to change it. The V6 engines have the crank sensors in the timing cover. But the 5.3L is a V8.