0
For a 2000 Lincoln LS, the torque specifications for the upper control arm bolts are typically around 85 ft-lbs for the upper control arm to frame bolts and about 50 ft-lbs for the upper control arm to spindle bolts. Always consult the vehicle's service manual for the most accurate and specific torque values, as they can vary based on specific configurations or updates. Ensure to use a torque wrench for accurate tightening.
What else can I help you with?
What is the torque specs sequence for a intake manifold on a 2002 Lincoln ls 3.0 dual overhead cam?
There is no torque spec for the air filter --it sits in its housing which snaps open and closed.The intake manifold torque specs are 89 inch pounds (7.5 ft.lbs.), that is for both the upper and lower intake.
What is the torque on intake of 1997 34?
torque specs are lower intake 115in-ibs upper intake 18ft-lbs
What is the torque specs for the upper intake on a 2001 dodge stratus 2.7?
105 in lbs
What is the torque pattern on the upper intake on a 5.7 vortech?
www.boxwrench.net get to the specs, and they'll give a diagram.
What are the Torque specs acura tl 3.2 upper intake cover?
8.7 ft-lb
What are Torque specs for buick century 3.1 the plenum?
Correct torque on 2000 model : 18 Ft. lbs.- upper intake manifold [ plenum ].
Banshee case torque specs?
Crankcase mounting bolts: Upper Case 10Nm, Lower Case 25Nm
What are the torque specs for upper control arm mounting bolts?
The torque specifications for upper control arm mounting bolts typically range from 40 to 75 ft-lbs, depending on the specific vehicle make and model. It's essential to consult the vehicle's service manual for the exact torque values, as they can vary significantly. Additionally, always check if the bolts should be torqued while the vehicle is at ride height to ensure proper alignment.
What is the torque specs for upper intake manifold on a 2003 Malibu?
on 3.1 v6,it is---intake 10 ft lbs-----upper intake-18 ft lbs,
What are the torque specs on upper and lower intake manifold for a 2001 Pontiac grand am 3.4 liter?
lower intake is 115 in pounds upper is 18 ft pounds
What are torque specs intake bolts on 3.4l 2002 Chevy impala?
lower intake is 132 lb's upper intake is 89 lb
What is the torquing specs for the bolts on a 1999 blazer 43 intake manifold The book gives 132 pounds but this seems too much?
I FOUND THIS AT WWW.AUTOZONE.COM, CLICK ON VEHICLE SPECS . For your 1999 CHEVROLET TRUCK BLAZER 2WD: INTAKE BOLT TORQUE FOOT POUNDS (FINAL TORQUE) TORQUE LOWER MANIFOLD BOLTS TO 27 IN/LBS TORQUE LOWER BOLTS TO 9 FT/LBS TORQUE LOWER BOLTS TO 11 FT/LBS TORQUE UPPER MANIFOLD BOLTS TO 44 IN/LBS TORQUE UPPER MANIFOLD BOLTS TO 7 FT/LBS (TO TORQUE BOLTS & NUTS, START IN CENTER USING CRISSCROSS PATTERN)
