0
Add your answer:
Earn +20 ptsQ: Where is the oil pressure sensor on a 94 GMC 5.7?
Write your answer...
Submit
Still have questions?
Related questions
On 57 engine block in front of the oil filter there is a port for a sensor which system oil or coolant?
"Neither. Most likely for knock sensor. check other side in same location. There will most likely be a round sensor threaded into the block. no oil or coolant present.
My oil pressure alaways turns around 55 is that good or bad - I have a 57 L 1991 Chevy G20?
Good.
Oil pressure fuel pump switch where is it located 1994 57 z28?
there is only one oil psi sender on driver side bottom of moter try refrazeing the question
Is 94 over 57 a good pressure?
I presume you mean blood pressure of 94 / 57. It is a slightly low blood pressure as the normal range is 120 / 80
What does a blood pressure score of 87 57 mean?
Normal blood pressure is around 120/80. 87/57 would be considered low blood pressure.
What percent of oil is used in the US?
57%
What should the timing be on a 1992 gmc Yukon 57 tbi after disconnecting the computer?
The timing should be set at 0 degrees.
What percent of the oil used by the United states is imported?
57%
What should a teenagers blood pressure be?
Ideally your blood pressure should be below 120/80.
How do you change a oil sending unit on a 1993 Chevy 57 truck?
HUH???????????????????????????
How long for zucchini seeds to germinate?
57 days
Where is the IAT sensor on a 1988 Silverado 57 EFI and where are the ECU wires to hook your module on?
The IAT sensor is probably on the throttle body and you hook you module to the dianostics connector just under the driver side of the dash.
Copyright ©2024 Infospace Holdings LLC, A System1 Company. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Answers.