You could read my contribution on repacing brake pads on a Ford something either way it goes the same way replace calipers bleed system better system of stopping you might have to upgrade brake lines and master cylinder but it should go the same way. hope this helps send me a message via this srt account give me a message
The minimum rear brake rotor thickness on a 1996 Lexus LS400 is 15mm.
Lift the vehicle on a car jack, remove the tire, remove the brake shoe/calipers, and remove the old brake pads. Put in the new brake pads, replace the brake shoe/calipers, replace the calipers, and lower the car.
You can access the brake light bald through the trunk compartment. Remove the trunk liner from the tail light assembly. Push the brake light connector in and turn at the same time. The brake lightbulb will come out. Reverse the process to install the new brake light
Sticking brake calipers. This can be caused by moisture in the brake fluid which will cause the calipers to rust. Replace the calibers and replace all the brake fluid. It can also be caused by driving with your foot on the brake.
It is time to replace the brake calipers when they begin sticking closed or do not close all the way. You might also have a caliper that locks completely which needs to be replaced.
Remove the wheels and remove the 2 14mm headedbolts from the caliper and lift caliper from brake pads www.lextechautomotivellc.com
Lift the car on a car jack, remove the tire, remove the brake shoe/calipers, and remove the old brake pads. Next, dispose of the old brake pads, put in the new brake pads, replace the brake shoe/calipers, replace the tire and lower the car to the ground.
Lift the car, remove the tire and set aside, remove the brake shoe/calipers and remove the old pads. Replace the old pads with the new pads, replace the brake shoe/calipers, replace the tire and lower the car.
To replace your bike brakes, follow these steps: Remove the old brake pads and calipers. Install the new brake pads and calipers. Adjust the brake tension and alignment. Test the brakes to ensure they are working properly.
Lift the vehicle with a jack, remove the tire, remove the brake shoe/calipers, and remove the old brake pads. Next, put in the new brake pads, replace the brake shoe/calipers, replace the tire and lower the vehicle.
Lift the car, remove the car tires, remove the brake shoe/calipers and remove the old brake pads. Put in the new brake pads, replace the brake shoe/calipers, replace the tire and lower the car to the ground.
junkyard.