answersLogoWhite

0

  1. Disconnect the temperature control and air door control cables from the heater housing.Carfully position the cables out of the way
  2. Disconnect the electrical wires from the blower resistor and the blower motor
  3. Remove the retaining screws holding the air inlet vent duct to the main body of the heater housing
  4. Disconnect the wires from the heater blower on the engine side of the firewall
  5. Drain the water from the radiator and remove the heater hoses from the heater core on the engine side of the firewall
  6. Remove the heater body retaining nuts from the studs on the engine side of the firewall
  7. Remove the heater assembly from the passanger side of the firewall
  8. Remove the gasket situated between the heater hose end and the dash panel where the core inlet and outlet tubes pass through
  9. Remove the Blower fan from the motor shaft
  10. Remove the motor from the mounting plate
User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Where is the blower motor resistor on an 99 ford econoline 250?

on the blower houseing beside the blower motor


Where is the resistor for the heater motor on a ford E-250 van?

where is the blower motor resistor located on a ford e250 2001


Where is blower motor on 1996 Ford E-250 van?

Right behind the battery.


Why doesn't your ford E 250 blower blow on high?

If your Ford E-250 blower isn't blowing on high, it could be due to a faulty blower motor resistor, which regulates the fan speed. A blown fuse or a bad connection in the wiring could also be responsible. Additionally, the blower motor itself might be failing. It's best to have these components checked to determine the exact issue.


What would make a heater just turn off 0n a 1998 ford 250 van?

Blower motor wire fell off blower motor? Blown fuse? Resistor pack opened (opening electrical circuit) Bad switch?


Why does Heater blower on 2004 f-250 not work?

The resistor motor may have went out if the heater blower quit working on a 2004 F-250 Truck. The cost to replace the motor is approximately $200.


Will a 1973 Ford F-250 4x4 chassis fit a 1979 f250 4x4?

will a 1973 ford f-2504x4 chassis fit a 1979 f-250 4x4


How do you tell what size motor in Ford F-250?

what is the size of motor of Fordf250 1996


Where is the fuse for the blower motor located on a 1997 Ford E-250 Van?

there is no fuse its either the relay on the side wall in the drivers side front fender thats bad or its the hi low fan control dial in the dash or it can be what is called the blower motor resistor wich is just to the right of the blower motor itself the resistor controls the speed of the fan i think aswell so if its blowing but only a lil its probally the resistor.


What is the weight of a 1979 Ford F-250?

Two times the half


Where Heater blower resistor placement on a Ford pickup F-250?

under the left front tire


Why does my Ford f-250 blower only blow on high?

more than likely the blower motor resistor is out. it uses resistors to reduce the voltage sent to the fan to make it spin slower when the resistors go out on low and med your are left with high witch is battery voltage 12v.