How do you program a sears craftsman garage door opener 139.53879?

Answer 1

If you want to add a remote, press the "set" button on the power unit until the green light blinks, then press the button on the remote. If you want the unit to forget all old codes and accept only the new remote, hold the "set" button until the green light stays on solid, then press the remote button.

Answer 2

How do you program a sears garage door opener 139.53879?

Read more: How_do_you_program_a_sears_craftsman_garage_door_opener_139.53879

Answer 3

The "SRT" garage door openers have an "SRT" button on the rear panel of the opener (mine is round and green). Use this button to program and also to clear previous programming.

To clear previous programming, hold the "SRT" button for six seconds.

To program a transmitter, hold the button on the transmitter, and while still holding it, press the "SRT" button until the opener light flashes.

Answer 4

At the same time, press and hold the green button on the right side of the motor unit, and press the remote button. When the lights, (not the green light, but the side lights) flash. Release both buttons.

Answer 5

Press the purple learn button on the door opener power head, light will blink. Then press desired button on remote to control opener. Complete.

Answer 6

I have three genie garage openers and only 1 craftsman garage opener and i want to program the craftsman one to match the genie ones, how do you do this

Answer 7

Remove cover on module, find switch labelled pgm or operate.