Bettwen 100.00 to 300.00
not true that's how much you BUY them for.. Trade in value is most likely not worth it verrry very low as low as 25 ish maybe a little more if your lucky.... just keep it and practice on it and learn on it or if ya want reade it in for new strings or a tuner or stand not towards another guitar
I need more information but go here for answer.http://www.fender.com/support/product_dating.php it is a 1979 fender stratocaster tobacco sunburst bought brand new from swords music in fort worth texas by me and stolen in 2001 in a burgulary of my apartment srehill01@gmail.com
You need to supply more information; but if you follow the link below, you can enter the serial number and country of manufacture to get more information about the guitar.
Short answer, yes. Long answer, that would depend on the width of the neck, the action height you are attempting to achieve and whether or not the neck is from a stratocaster or telecaster. It would also depend on if you plan to use the original head. It also does not need to be a Fender patented neck if you are willing to put in design time. This long answer may require some woodworking and/or engineering skills, but it is not impossible.
No! You will need to have the model designed specifically for Rock Band 3. Other guitars without the touch detection in the neck or a way to interface with the xbox 360 will not work.
To determine the value of a Fender Stratocaster with the serial number 027196, you'll need to consider factors such as its model, year of manufacture, condition, and any modifications made. Serial numbers can help identify the production year; for example, if it's from the late 1970s or early 1980s, it might be worth between $1,000 to $3,000 or more, depending on its specific attributes. It's best to consult recent sales of similar models and consider getting an appraisal from a professional or reputable dealer for an accurate valuation.
I looked at my remote filter on my 93 S10 Blazer and it is bolted to the inner fender which shouldn't need to be removed to remove the fender.
To replace the Sunfires fender, you will need to disconnect any wiring (marker lights) connected to the fender. With a helper, unbolt the fender then set it off. Check for any tack welds that may be holding the fender on as well.
A CRF fender can fit on a 2001 XR250 with slight modification. The rear of the fender will need to be trimmed as it will not clear the body of the motorcycle from the front fork.?æ
It is inside the driver side fender. You need to remove the fender liner to access.
horn is located under the left front fender u need to remove inner fender to get at it
first would be to remove the headlight and turn signal. remove any bolts behind there holding the fender. remove the screws holding the inner fender to the fender. at the bottom of the fender behind the tire there are 1-2 bolts that need to be removed. now open the door and remove the fender bolt/s in the door jamb. last is to remove the 4-5 bolts along the top of the fender under the hood holding the fender to the appron.
Getting the alignment(gap) right is the hardest. Just need to remove the headlight, raise the hood unbolt the fender bolts. The fender bolts near the door jam, You get access with the door open. You might need to remove the bumper to remove.