0
What else can I help you with?
Where is the cam sensor on a 1996 Land Rover Discovery?
at the front of the engine beneather the camshaft pulling
Where do if find the crank positioning sensor for a 2000 land rover discovery?
They sell them at Autozone for about $160.00 www.autozone.com
How do you replace the camshaft position sensor on a 1997 land rover discovery?
To replace the camshaft position sensor on a 1997 Land Rover Discovery, first disconnect the battery to ensure safety. Locate the sensor, which is typically found on the engine block near the camshaft. Remove the electrical connector and the mounting bolts, then take out the old sensor. Install the new sensor by reversing the removal steps, securing it with bolts, reconnecting the electrical connector, and finally reconnecting the battery.
Where is the camshaft position sensor on a 1996 land rover discovery and how do you install it?
On a 1996 Land Rover Discovery, the camshaft position sensor is typically located near the front of the engine, often on the cylinder head. To install it, first disconnect the battery and remove any necessary components for access. Then, unplug the old sensor, remove the mounting bolts, and replace it with the new sensor before securing it and reconnecting the electrical connector. Finally, reassemble any components you removed and reconnect the battery.
Where is the camshaft sensor on a 03 land rover discovery?
On a 2003 Land Rover Discovery, the camshaft position sensor is typically located near the front of the engine, often near the timing cover or cylinder head. It's usually mounted on the cylinder head or the engine block, depending on the specific engine configuration. To access it, you may need to remove some components, such as the intake manifold or other covers, depending on the vehicle's layout. Always refer to a service manual for precise location and removal instructions.
What is error code P0154 land rover discovery 2003?
O2 sensor cicuit no activity (bank 2 sensor 1)
Where is the oxygen sensor on a 1995 Land Rover discovery?
On the exhaust header right ahead of the catalytic converter.
How to replace a 2002 land rover discovery crank shaft sensor?
"http://wiki.answers.com/Q/How_to_replace_a_2002_land_rover_discovery_crank_shaft_sensor"
How do you repair a speed sensor on 99 land rover discovery 1?
You replace it. Should be next to the trans case.
How do you replace a crankshaft sensor on a 1997 Landrover Discovery?
Begin by removing the rear engine cover from your 1997 Land Rover Discovery. Remove the crankshaft sensor wiring harness. Remove the crankshaft sensor retaining bolts. Reverse the process to install your new crankshaft sensor.
When was Land Rover Discovery created?
Land Rover Discovery was created in 1989.
What is a P1193 code on 1997 Land Rover discovery?
o 2 sensor circuit open down stream of converter
