Look by valve cover. Be careful, some cars requre a special alignment tool for installing cam sensors.
It is located on the backside (drivers side) of the engine at the end of the exaust cam. It requires a number 30 torx bit to remove it. 2 screws hold it in and no special alignment tools are needed to replace it.
where are the flashers located
The 1994 Volvo 850 crankshaft position sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft position sensor.
The 850 does not use a MAP sensor. It uses a MAF sensor that is located and attached to the air filter housing lid
On a 1994 Volvo 850 sedan, the oxygen sensor is typically located on the exhaust manifold or just after the catalytic converter. For the pre-catalytic converter sensor, you can find it on the exhaust pipe leading from the engine. The sensor is usually threaded into the exhaust system, making it accessible for replacement or troubleshooting. Always refer to the vehicle's service manual for specific details and diagrams.
You ought to be able to get at them from inside the truck.
All oxygen sensor are in the exhaust either before or after the catalytic convertor.
On a 94 Turbo DSM there is no crank angle sensor. The Cam Angle Sensor(CAS)serves the function of both a crank and cam sensor, and it's located on the passenger side of the valve cover at the end of the intake camshaft, you can't miss it.
it is located behind the ash tray just up from the gear stick. the ash tray pulls out and the fusebox is just behind it.
located on the transaxle.
The vehicle speed sensor, on your 1994 Chevrolet Silverado pickup truck, is located on the back of the transmission. The speed sensor is labeled as such.
http://www.swedishautoparts.com/850/volvo-850-electrical-parts.html Try this website for a pdf. Hope it helps, Troy
inside the trunk