0
What else can I help you with?
How fast can a 2011 Raptor 125 go?
the 2011 and 2012 yamaha raptor 125 can top out in 5th gear at the exact speed of 54mph on a staight away.
How much gear oil for 700 Yamaha raptor?
The Yamaha Raptor 700 typically requires about 1.5 quarts (1.4 liters) of gear oil for the transmission. It's essential to check the owner's manual for the specific model year, as recommendations may vary slightly. Always use the recommended type of oil, such as Yamalube or an equivalent high-quality gear oil, for optimal performance.
How fast is a raptor 125?
The Yamaha raptor 125 goes 35 to 42 mph. I don't have one but my friend has one and on a garmin gps it says 42 mph. That is on 5th gear pinned. My raptor 250 goes 55 mph and I am 11
How gear are taking in Yamaha FZ byk?
how gear are shifted in Yamaha FZ byk
Timing marks for Yamaha 660 2002 raptor?
you have to have the 2 holes that are in a line on the cam on the top center and the dot on the top gear top center and line the dot on the bottom gear up with the arrow above the gear to line the bottom gear up you have to have the clutch assembly off. just remember everything has to be top dead center
What brand of motorcycle street gear goes with Yamaha?
Yamaha
Where is neutral on a 1984 Yamaha Virago xv 700?
The neutral position is usually between first gear and second gear. Put the bike in first gear then push up that should put it in neutral.
What is the gear oil capacity for a 1995 Yamaha yz250?
On a dry fill it's 800 mil, for an oil change 750 mil
Why won't my Yamaha Bruin shift out of low gear?
Your Yamaha Bruin may not shift out of low gear because something may be wrong with the gear box, so you should have it checked.
When you put your 660 Yamaha raptor in gear while idling it wants to lurch forward and chatter noice from somewhere any ideas?
It means your clutch is dragging. It sounds like the clutch friction disks are worn and its dragging and making the chattering noise
How do you change gear lube on Yamaha 200e?
To change the gear lube on a Yamaha 200E, start by locating the drain plug on the lower unit and removing it to let the old gear lube drain out completely. Once drained, replace the drain plug securely. Next, use a gear lube pump to fill the lower unit with fresh gear lube through the vent hole until it starts to seep out. Finally, replace the vent plug and ensure everything is tightened properly before testing the motor.
Yamaha R1 max speed in first gear?
2007 R1 tops at 101 then rev limiter hits. this is my experience
