answersLogoWhite

0


Best Answer

the easiest way is to get a regulator, a new one then screw it on the handlebars.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you install regulator on motor cylcle kawasaki ar80?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace window motor 1996 Chevy Astro?

1. Remove the power window regulator2. Install a pan head sheet metal tapping screw through the sector gear and the backing plate at the hole provided to lock the sector gear into position. Then drill out the motor to regulator attaching rivets.3. Remove the motor from the regulator.To install:1. Lubricate the motor drive gear and the regulator sector teeth. Install the motor to the regulator and check the mesh of the motor to the regulator.2. Install rivets to the motor and the regulator.3. Remove the sheet metal tapping screw.4. Install the power window regulator.


Remove and install window motor and regulator Buick Regal 2002?

Complete instructions with photos:


How do you replace a window motor on a 1998 Pontiac Firebird?

The window motor is attached to the window regulator by screws. After removing the door trim you must detach the regulator from the door by drilling-out four rivits. Then remove the screws from the old motor and install the new motor. Re-attach the regulator with bolts and put the trim back on the door.


Why wont driver side window work on ford ranger?

It is most likely a broken window regulator or bad electric motor. Don't know about the cost of the motor but the regulator will run $40-$70 + labor to install.


How do you replace just a window regulator not the motor?

You have to drill the rivets on the motor separating it from the regulator. The new motor then mounts to the regulator and you insert the new bolts where the riverts were.


How do I replace a window regulator for a 94 Toyota Camry?

Remove the door panel. Use a coat hanger or ty rap to secure the window in the up position. Disconnect the wiring from the motor. Remove the bolts that secure the glass to the regulator. Remove the regulator. Install motor on new regulator. Installation is the reverse procedure. 6 to 8 bolts in entire process. Good Luck. CAH


How do you know where on a the gear to install a new motor for the drivers side window of a 1999 acura integra?

It does not matter, the motor will continue to turn either way until stopped by the window regulator.


Need a starter motor for kawasaki gtr 1000?

need a starter motor for a kawasaki gtr 1000 h reg


How do I correct fuel pressure too lean on Honda CRX?

install a fuel pressure regulator and set it to 36 psi idle in a stock motor


Why would a 2002 Cadillac Deville rear passenger window not roll up?

the regulator and motor need replaced. they can both be ordered on line for about $65. and have a local car window shop install them for a $100 or less. the regulator will come with the motor installed. just make sure you order the new regulator with motor. a local cadillac shop or window repair shop will try to charge you over $500 to fix


How do you replace achieva power window motor?

Remove the window regulator assembly from the door.Remove the motor from the regulator by drilling out the attaching rivets with a 3/16 in. drill bit.Connect the window motor to the regulator with 3/16 in. rivets.Install the window regulator assembly.


How do you change the power window motor on a 1994 Pontiac Grand Prix?

Remove the window regulator and motor from the door as an assembly. Drill out rivets that hold motor to regulator and replace motor. Regulator needs to be riveted back into door for reassembly