The 2000 Pontiac Montana has the most common hook-end wiper arms. See the Sources and Related Links section below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.
The rear window wiper motor on a 2001 Chevy Tahoe is changed by removing the inner trim and disconnecting the wiring harness. The mounting bolts and wiper arm can then be removed and a new motor installed.
In many cars, there is only a single wiper motor. One wiper arm is attached directly to the wiper motor and the other through a linkage. If one is working, the motor is operating but the connection to the other may be broken.
If they are going on by themselves, check the wiper switch or the connections on the wiper motor. More than likely it is a bad switch.
Either the fuse is blown or the wiper motor is bad.
If the motor works on high, or any speed, then it's fine. Switches and resistors control speed and delay.
You need to purchase a new motor. You can purchase one at a dealer, a parts store, or even a junk yard if you get lucky. If you don't know how to fix this yourself you should take it into the shop to have it done properly, and if you still have a warranty the dealership should be able to get you into their service department. Good luck. There are two screws under the dashboard top plate, and two nuts at the windshild wiper post. That's only if you want to do it yourself. put 'masking' tape on both sides of you present wiper positions. About 2 hours. Care on the screws that hold the dash plate should be observed. It's plastic and fragile.
A electric motor that moves the (window) wiper to clean the window.
Its your linkage, not your motor.
It is attached to the wiper motor.
get a mechanic
how do you change wiper motor on e250 1992 van
Remove the wiper arm from the wiper motor. Remove the wiring harness from the wiper motor. Remove the wiper motor retaining bolts. Reverse the process to install the new wiper motor.
how to change the windshield wiper motor in a 2000 jeep wrangler
Wiper arm travel rod from the wiper motor. Remove the wiper motor wiring harness. Remove the wiper motor retaining bolts. Reverse the process to install the new wiper motor.
if the shaft of wiper motor is moving you probably have stripped gears in wiper arm or the nut to hold wiper arm in place is loose
Remove the rear wiper arm from the wiper motor. Remove the wiring harness from the wiper motor. Remove the wiper motor retaining bolts. Reverse the process to install the new wiper motor.
How do I change a Wiper motor for a 99 dodge avenger?
how do you replace a wiper motor in a 2000 jetta?