YOUR HOT WATER TANK NEEDS TO BE REPLACED == Answer== It could be cross connected, I would turn on any faucet, then go listen at your washing machine and see if you hear water running through the hot and cold valve where your hoses hook on. If you do you need to replace valve on machine. If it is a new house they may have tied the hot and cold water together. That is very very hard to find. You would have to call a plumber for that and then hope for the best. Still try the washer even on new house.
Not always, but they should be. The convention in plumbing was to have cold on the right and hot on the left. This was only written into some US building codes (Southern Building Code) in the past 10 years.
put them under cold water for 15 to 20 minutes.
It depend on how long you spent in there if you spent a year in there it prbally would
It was cold because the sinking was in April, the early spring, and it was in the North Atlantic Ocean. Salt water has a lower freezing point than fresh water - what this means is, if you imagine being in a wading pool of ice cubes, the water that night would have been COLDER than that.
yes randy is a fooking dook
Obviously hooked up wrong, or the faucets are mismarked . Usually cold on the right, hot on the left.
There is a hot/cold cross connection at one or more of the faucets at you house. make sure all faucets are shut off both hot and cold. If it still occurs more than likely you have a Moen faucet somewhere (most likely).
water pressure
old galvanized piping
Lots of stuf can cause it including sediment or a blocked supply line
Low water pressure or cold water main undersized.
Stopped at all faucets? Didn't pay the water bill. If in cold climate, the line from the outside to probably the water heater has probably frozen.
To protect outdoor faucets from freezing, you can insulate them with faucet covers or wrap them with towels or foam. Additionally, you can shut off the water supply to the outdoor faucets during cold weather and drain any remaining water from the pipes.
If you are referring to a regular building, the cold water feed pipe goes directly to all cold faucets, toilets and hot water tank. The purpose seems obvious.
Usually red. For example, if you want to use colors to label hot and cold faucets, the hot would be red and the cold would be blue.
Cold water may be coming out of the hot water faucet due to a malfunction in the water heater, such as a broken heating element or a faulty thermostat. This can cause the water in the tank to not be heated properly, resulting in cold water coming out of the hot water faucet.
A hot water heater is designed to supply hot water to faucets, not cold water. It is not possible for a hot water heater to siphon into a cold water faucet. Each faucet is connected to either the hot or cold water supply lines, which are separate in a plumbing system.