1999 Jeep grand Cherokee power windows wont workon every door?

Answer 1

Make sure the window lock button is not engaged on the drivers door. If the button is not engaged then there is a short on the window lock switch. Answer 2:Had to replace the complete drivers door switch assy.I believe rainwater from the driprail falling on the switches is the cause($255.00 from dealer)

Answer 2

this is how my Chilton says to do it lower window to down position(if you can) remove door panel remove window weather stripping remove black window surround (should be a screw on top of surround towards back edge) then stationary window should unbolt then remove pins that hold operator to track pick up and pull out the operating window

Answer 3

most likely the wires in the door on the drivers seat side disconnected, our window quit working sometimes, when we give a good Bang! against the the door next to the panels it works again... u can try that out, if not still, past by a garage...

Answer 4

Sounds like a problem with the master (drivers) switch.

Answer 5

mine did the same thing> it was a broken wire int he rubber boot going from the drivers door to the pillar (by the door hinges). just slide the boot off and check your wiring.

Answer 6

Check for a broken wire in the jamb between the drivers door and the body.