answersLogoWhite

0


Best Answer

First, I would check the fueses, below the dash by the drivers feet. If not that, you should check the switch, try inter-changing it, if that doesnt work, you should check for burnt wires. I've had this problem before.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

16y ago

Do parking/tailights work? Should be the same fuse Could be an open in the dimmer rheostat Could be a bad switch

This answer is:
User Avatar

User Avatar

Wiki User

9y ago

The speedometer, tachometer, and fuel gauge will not be working on a 1992 Jeep Cherokee if the fuse has been blown. Alternatively, the wiring can become disconnected.

This answer is:
User Avatar

User Avatar

Wiki User

12y ago

Check the under hood fuses. It may be one of the tiny ones - 20 amp I think.

This answer is:
User Avatar

User Avatar

Wiki User

9y ago

If the gauge lights on your Jeep will not work and the jeep will not start you could have a dead battery. If the terminals look corroded, It is possible that the terminals just need cleaned.

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: No dash lights or gauges not working on dash board on 1986 Jeep Comanche?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is wrong when your gauges on dash board stop working on your 1997 Chevy astro van?

what is wrong when your gages on dash board stop working on your 1997 chevy astro van?


Why are your dash board lights and interior lights not working on your 93 Ford Taurus?

check your fuses


Where does the dimmer module located on a Nissan bluebird?

why is my dash board lights not working


Why do the gauges on a 2000 grand caravan stop working?

A common reason for this is a cracked circuit board in the instrument panel. Do any of the warning lights come on at the same time (ABS, for example)? If you smack the dashboard with your hand sometimes you can make the gauges come on again. It'll likely need a new instrument cluster. --Dennis, ASE Master Tech


How do you change the dash lights in a Elantra 2001?

Do the interior lights work in the gear selector or the climate controls? If none of them work, suspect a fuse or something else. If it's just behind the gauges and all have gone out, then the board behind the gauges may be fried. But assuming none of those are the case, you'll need to remove the dash and the bulbs are located behind the gauges. Not a task for the timid.


My dash board lights and tail lights are not working and my service engine light comes on. How are these connected and how can I fix the tail lights so they are working so I can pass inspection in NJ?

check the fuse and the park lamp relay


2000 Cadillac dts Dash board lights not working?

There are several things that can cause your 2000 Cadillac dashboard lights to quit working. The most common cause is a blown fuse.


How do you replace the dash board light on a 1997 Isuzu Rodeo?

you have to take off the dash board panels. these screws will be over the radio, behind the ashtray, under dashboard over the gauges, and the last set will be on each side of the steering wheel. u can then see the 4 screws for the gauges and just remove screws, reach back and twist bulb out. i would suggest changing all four at the same time because if one goes out they all will. i learned the hard way Is that the only thing not working? check your tail lights. you will still have brake lights but if you blew a fuse your running lights , tail lights and dash are all on the same fuse. mine kept blowing it was a bad ground by the alternator.


The rear windshield wiper and running board lights are not working what could cause this?

the fuse that controls the interior lights, running board,an rear wiper is blown. it is a 15amp fuse in the panel. Also,try the cluster dimmer position since it controls the running board lights and exterior mirror lights as well.This dimmer is located next to the headlight switch.Good luck!


Tail lights and dash board lights not working on 96 Jeep Cherokee classic?

Check your fuses again-use test light. Almost always seems to be a fuse when both tail lights and dash lights aren't working at same time. If that fails, check headlight switch


Why don't my dash board gauges work?

Check your fuses.


What could be the reason for dash board lights and tail lights not working on a 1989 Mercury Sable even after the fuses have been replaced?

Is there a penny stuck in the lighter port?