I think I can answer my own question. Went to Walmart and found a brake light for a tow hitch, with a logic circuit on it for $10. I also purchased a converter from a 7 way trailer hitch plug to a 4 way, which is needed for the trailer hitch light. It also was $10. so I will tap into the logic circuit to the third brake light. for $20 it solved my problem. Thought I would pass this along.
Often a dealer will let you get a copy of that page from the shop manual. Remember that they don't HAVE to give it to you, so be respectful when you ask for it.
coil and disribuitor elecrtic wireing?
Check bulbs Check switch
I do not know about a 1988 Isuzu PU, but I have a 1992 and the vacuum diagram is on the underside of the hood. You may need to clean it up a bit to see it. I did. Hope this helps. morempg2u
You can only do that if there is a pickup installed in the ukulele. The pickup will have a standard amplifier jack in it. If there is no jack, there is no pickup!
what you are asking is who invented the electric guitar. not the guitar pickup. without the pickup its just a piece of wood.
The Switch may be bad. Check the bulbs for the parking lights. Check the fuses / relays for the parking lights.
i have tail lights but do not have brake lights nor do i have turn signals. i have replaced brake switch and all bulbs
you need to replace blinker can in your vehicle. the flashers and blinkers have separate flasher cans which is why your flashers still work but not your blinkers
See the link below and click on Owner Guides.The Owner Guide ( which includes the fuse diagram ) can be viewed online.
Yes. send email. i have a complete wiring diagram. rbrown@appeara.com
If both blinker and hazards dont work check your flasher switch.
the hazard switch has two sets of contacts. when hazards turned on, blinkers cannot work,even if hazards dont work.for blinkers to work, hazard sw must be in off position-this reconnects blinker circuits to work normally. BUT-the contacts in the hazard sw get dirty and wont reconnect the blinkers to work
Day Light Running Lights.
When replacing or fixing brake lights it is important to have a diagram to have make sure everything is done correctly. A 3rd light wiring diagram for this car can be found in its maintenance or repair manual.
When working on anything electrical it is important to have a diagram for safety reasons. The wiring diagram for a 1995 Toyota pickup radio can be found in the maintenance manual.
If there is no brake lights on a 1998 Mazda pickup, check the fuse. If the fuse has blown, the lights will not work.
Check the bulbs. These bulbs are a combination tail light & brake light. Even though the blinkers work, the brake light part might be burnt out. If these are okay, check the brake light switch. It's mounted on the brake pedal. Are the brake lights on all the time or they don't light up at all? if all the bulbs are fine, its more than likely the stop-light switch underneath the brake pedal.