answersLogoWhite

0

intake manifold

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Where is the MAP sensor on a 2003 Ford Ranger 2.3L?

On the 2003 2.3 liter 16 valve engine, the MAP sensor is located on top of the intake manifold (black) toward the back (firewall). It has 3 wires coming out toward the passenger side. The OEM part # is 1S7A-9F479-AB.


Of the 16 deserts on the map how many are located north of the equator?

11


Of the 16 deserts on map how many are located north of the equator?

11


Where would Vienna be located on a map?

On a map, Vienna is located at 16' 21' 0, 48'13'N. It is located in Central Europe, in Austria. It is between the eastern fringe of the Alps. Vienna has an area size of 414.87.


Zafira 2.0Ltr DTI 16 v how much dual mass flywheel cost?

200 quid from megavaux


Where is cooling fan sensor located on a vauxhall corsa with a 1.2 16 valve engine?

on raidator under the water horseess


How do you remove map sensor on 5.7l dodge hemi?

Using a 5/16 driver loosen the clamp on the air intake, remove the air intake, loosen two nuts on cover to throttle body remove cover, then unplug the connector to the map sensor turn sensor quarter turn counter clockwise and pull out, just had that problem myself took me some research to figure it out too. good luck


Where to find Dialga in Pokemon lake?

you can find dialga in map 16 you can also find arceus in map 16 too


Where is the oil pressure sensor on an 2006 Chevy Express?

It is located in the rear of the engine. You must remove the engine cover inside the cabin. The sensor is in the middle, back of the engine. Assuming the engine is in front of you. It requires a deep socket size 1-1/16 to remove sensor.


Where is Natwest Offshore located?

Natwest Offshore is a bank located in New Jersey, at 16 Library Place, St. Helier. A map route to this addressed can be searched on the Internet or using a global positioning system.


How do you replace the crankshaft sensor on a 1994 Dodge Ram?

The crank sensor is located behind the passenger side head, in through the bell housing. It is held in place by two bolts that require a 5/16 Allen socket to remove.


Where is the speed sensor on a 2003 harley Davidson fat boy?

speed sensor is located to the rear of the transmission chrome (retangular) cover. there are four bolts on the cover, if you are looking at the bike from the right side just behind the cover rear bolt is the speed sensor. loosen and remove Allen bolt with 3/16 Allen and rotate sensor just enough to pry out. it is in there snug. i just removed and cleaned my sensor. there were metal shaving. My symptoms were no speedometer , odometer, and turn signal not turning off after conmpleting turn.