Cadillac Brougham

To replace the hood ornament on a 1989 Cadillac Brougham, first, ensure the vehicle is parked safely and the hood is open. Carefully pry off the old ornament using a flathead screwdriver or similar tool, taking care not to damage the hood. Once removed, clean the area if necessary, then position the new ornament in place and secure it by either pushing it into place or using screws, depending on the design of the new ornament. Finally, close the hood and check that the new ornament is securely attached.

The heater fusible link for a 1987 Cadillac Brougham is typically located near the battery or the starter motor, connected to the wiring harness. It is designed to protect the heating system's electrical components from overload. To access it, you may need to remove some engine covers or components for better visibility. Always consult the vehicle's service manual for specific diagrams and instructions.

If your 1989 Cadillac Fleetwood Brougham won't drive over 30 miles per hour, it could be due to several issues, such as a malfunctioning transmission, a clogged fuel filter, or problems with the throttle or engine. It’s also possible that there could be issues with the ignition system or a failing sensor. To diagnose the problem accurately, it’s best to have a mechanic perform a thorough inspection and check for any diagnostic trouble codes. Regular maintenance can help prevent such issues in the future.

To remove the door panel on a 1991 Cadillac Brougham, start by removing any screws securing the panel, typically located near the armrest and around the edges. Next, gently pry off the panel using a flathead screwdriver or a panel removal tool, being careful not to damage the clips. Once loose, disconnect any electrical connectors for power windows or locks, and lift the panel away from the door. Make sure to keep track of all screws and clips for reassembly.

Your 1991 Cadillac Brougham may be stalling due to several potential issues, such as a dirty or failing idle air control valve, a clogged fuel filter, or problems with the fuel pump or ignition system. It could also be related to vacuum leaks or a faulty throttle position sensor. To diagnose the problem accurately, consider checking error codes if available, and consult a mechanic if the issue persists. Regular maintenance can often prevent such stalling issues.

I'm sorry, but I can't assist with that.

The transmission vacuum module on a 1989 Cadillac Brougham is typically located on the transmission itself, near the throttle linkage. It is usually mounted on the driver's side of the transmission case. To access it, you may need to lift the vehicle and remove any undercarriage components that obstruct your view. Always refer to a service manual for specific details and diagrams for your model.

The airbag light on your 1993 Cadillac Fleetwood Brougham may stay on due to a malfunction in the airbag system, such as a faulty sensor, a damaged wiring harness, or an issue with the airbag control module. It could also indicate that the airbag system has been deactivated due to a safety concern. It's important to have the system diagnosed and repaired by a qualified technician to ensure the safety features are functioning properly. Ignoring the warning light could compromise your safety in the event of an accident.

265/35/22 tires are unlikely to fit a 1990 Cadillac Brougham without significant modifications. The Brougham typically comes with much smaller tire sizes, and fitting larger tires often requires changes to the wheel wells, suspension, and possibly the vehicle's overall stance. Additionally, the 22-inch wheel diameter may not be compatible with the stock rims or suspension setup. It’s recommended to consult with a tire and automotive specialist to ensure proper fitment and safety.

In a 1979 Cadillac Fleetwood, freeze plugs, also known as core plugs, are typically located on the engine block. They are used to prevent damage from freezing coolant by allowing expansion if the coolant freezes. You can find them on the sides and sometimes on the rear of the engine block, usually made of metal and slightly recessed into the engine. If you're looking to inspect or replace them, it's advisable to consult the vehicle's service manual for specific locations.

Changing the throttle position sensor (TPS) in a 1995 Cadillac Fleetwood Brougham can be moderately challenging, depending on your mechanical experience. The TPS is typically located on the throttle body, which may require some disassembly to access. Basic tools will be needed, and it's essential to ensure proper calibration after installation for optimal performance. Overall, with the right tools and instructions, it can be a manageable DIY task.

A 1993 Cadillac Fleetwood typically uses a variety of bulb sizes depending on the specific application. For the headlights, you would generally need H6054 bulbs. For interior lights, you might use 194 bulbs, while the brake lights often require 1157 bulbs. It's always best to consult the owner's manual or check the existing bulbs for precise specifications.

its probably the fuse for the cigg lighter. Check that right under the steering column. It should be marked.

http://www.modifiedlife.com/1990-cadillac-brougham-car-radio-wire-guide/

this might help im having the same issue

you remove the battery hold down brace and voala! its done!

One fuse panel is below L/S dash, the other is under the hood L/S

It is in case you get stuck in the trunk. If you do then you just have to pull the lever and it will pop the trunk from the inside.