0
Chevy Avalanche
Chevy Avalanche is a sport utility truck produced by General Motors that has five or six seating capacity. It is distinguished by its removable rear window and back seat open bed which can be opened via a folding panel.
1,380 Questions
How do you remove dash on avalanche?
if your wanting to just remove the instrument cluster, go to this site
http://home.comcast.net/~digital_dash_solutions/silverado_removal.HTML
Where is the amplifier in a 2002 avalanche?
the audio amplifier is located behind the glove box to the right, slightly bend the right side of the glove box and gently let it down look to the right and there it is
How do you install front door speakers in 2002 avalanche?
1.- remove the doors panels
2.- remove the old factory speakers
What aftermarket tonneau covers fit the 2002 to 2006 Avalanche?
That is a tough one. I checked the application guides for Advantage, AgriCover (Access), BAK, Extang, Lund, Pace-Edwards and Truxedo. None of these producers made a model for the 2002-2006 Chevrolet Avalanche. Sorry.
Where can one find a Chevy Avalanche for sale in the UK?
If you live in the United Kingdom and are looking to purchase a Chevy Avalanche, the first place to start would be the Auto Trader UK. Another place to check out is Preloved Cars UK.
Drivers door adjustment on a Chevy?
I actuaklly had the same problem realigning doors that I had to replace and I found it alot easier to go to a body shop and pay $45.00 a door to have it done. I worked on them for over a week and got them close by loosening and tightening them but it was a big hassle. not the answer you were looking for but its the first
Thank you very much
Install water pump 2003 Chevy Avalanche?
1. Put the lime in the coconut and shake it all up
2. Check for leaks
3. Add Anti-Freeze
4. Road Test
Is there a fuse for the speakers in a 2003 Chevy Avalanche?
I bought a used 2003 avalanche and the soeakers have no sound. Radio works and has power but no sound. They seem to be connected (speakers) so is there a fuse maybe
Why is my 2004 Chevy Avalanche squeaking while I drive?
possible bushing in you suspension, swaybars, shock bushings, bad shocks. if it happens at slow speeds, get another person to listen for it as you drive and try to focus on the area. should be able to locate it if that's the case. or try pushing down on the bumpers to simulate bumps and listen for the sound.
What is the horsepower of a 10054727 engine?
1988-199? these motors were tbi and had 230 horsepower.swirl port heads.only good to 4500 rpm stock, any higher rpm will not make anymore power.
List they year and engine size and I will give you the answer. These numbers mean nothing to me.
How do you program the keyless remote for a 1998 expedition?
Replacing lost transmitters
Take all your vehicle's transmitters
to your dealer for reprogramming
if:
² a transmitter is lost or
² you want to purchase additional
transmitters (up to four may be
programmed).
To reprogram the transmitters,
place the key in the ignition and
switch from OFF to ON eight times
in rapid succession within 10
seconds. After doors lock/unlock,
press any button on all
transmitters (up to four). When
completed, switch the ignition to
OFF.
All transmitters must be
programmed at the same time.
Where is oxygen sensor bank 2 sensor 1 located on a 2003 5.3 Chevy Avalanche?
Bank 1 = driver's side
Bank 2 = passenger side
Sensor 1 = front (ahead of cat unit)
Sensor 2 = rear (after cat unit)
chevy avalanche has two catalytic units, one below each exhaust manifold on the exhaust "Y" pipe. there is an oxygen sensor before and after each catalytic unit. Typically replace sensors in pairs (before and after sensors on one bank). Always check your engine codes and look up the description of the code as it will tell you specifically which sensors and what failure is taking place.
Where is the oil drain plug on a Chevrolet 5.3 L engine?
The drain plug would be located at the lowest point on the oil pan. It usually takes a 15mm wrench to remove.
Nope you do not have to replace the sponge. Air filters differ a lot from different suppliers. The sponge is just added protection that is not required to run your wrangler safely.
Wheres the oil pressure sending unit on a 2002 Chevy Avalanche?
It's at the very back of the block, top-center, under the intake manifold.
How do you remove front door speakers of 1999 eclipse?
You have to remove the door panel. After you will see the speaker which sits in 4 screws. Remove the screws disconnect the speaker and in the reverse order for your new speaker. Keep in mind, whatever new speakers you get, the stock amp on this vehicle has a low pass filter to the door speakers (and a high pass filter to the dash) so they won't deliver any highs.
Where is the Crankshaft position sensor located on a 2002 Chevy 8.1?
rear of engine block, drivers side, midway between top and bottom of block, one 10mm bolt holds it in place
Where is the knock sensor on a 2002 Chevy Avalanche?
They (2ea.)are in the intake. The intake manifold will need to be removed to get to them. The wire harness and intake manifold gasket should both be replaced when reassembling.
How many gallons in a 2007 Chevy Avalanche gas tank?
The fuel tank capacity is 31 US gal (117 L, 25.8 Imp. gal).
Where is the location of the oil pressure sensor on a 2007 Chevy Avalanche?
i believe it is located on the top [center to right] rear of motor. a Chevy mechanic told me the intake manifold and fuel inj. had to be removed to get to it. i will soon find out for myself.
It may depend on what engine you have. I have a 2001 Corvette with the LS1 engine, the Oil Pressure Sending Unit is located on the top of the block, behind the Intake Manifold, and requires removing the intake or cutting a hole in the cowl to access it. I could not bring myself to start cutting holes in the body. When I read some one say that this is how they did it......instantly the word HACK came to mind. Take pictures or notes as you do it, there are a lot of steps, but none of it is rocket science. If you have everything there, gaskets, sending unit, etc., it is not a bad job. On the vettes, I have read it is a common problem more then likely due to heat, so I bought some fittings, made up an adapter, and relocated it so it can be changed without removing the manifold.
are all the electrical connections intact to the transfer case? Or are they ripped off? Is your shift linkage bent or broken? what happens when you grab the shifter and shift it?
Crawl underneath and have a look to make sure your linkage is intact and adjusted to shift properly and engages transfer case all the way in to position(invite a friend((slave)) over for beer and get them to shift it in and out while you watch the action). There is a contact at your shift linkage(similar to the one that lights your brakes when you press the pedal) that when shifted into four wheel drive turns light on, is it there and functioning(take a digital multimeter and test for power shift it in and out of four wheel drive?
Most importantly get a hanes manual for your truck it will help a great deal. I think your problem is simple, and you should check all the things i told you above first.
i am not a mechanic by trade but i have rebuilt a few vehicles in my day and that's what i'd try.
sIGNED bACKyARD mECHANIC
are all the electrical connections intact to the transfer case? Or are they ripped off? Is your shift linkage bent or broken? what happens when you grab the shifter and shift it?
Crawl underneath and have a look to make sure your linkage is intact and adjusted to shift properly and engages transfer case all the way in to position(invite a friend((slave)) over for beer and get them to shift it in and out while you watch the action). There is a contact at your shift linkage(similar to the one that lights your brakes when you press the pedal) that when shifted into four wheel drive turns light on, is it there and functioning(take a digital multimeter and test for power shift it in and out of four wheel drive?
Most importantly get a hanes manual for your truck it will help a great deal. I think your problem is simple, and you should check all the things i told you above first.
i am not a mechanic by trade but i have rebuilt a few vehicles in my day and that's what i'd try.
sIGNED bACKyARD mECHANIC
Most likely a vacuum leak. Check the lines around the injector pump. Paid dealer to fix mine and this is what they found.
