answersLogoWhite

0

Chevy Camaro RS

This category covers questions about the RS custom option for the first generation (1966-1969) Chevrolet Camaro. The RS package included hidden headlights, revised taillights, RS badging, and exterior rocker trim.

2,274 Questions

What is happening when the coolant reservoir is overpressurized and starts leaking from the cap Is this a thermostat problem or cooling fan switch problem?

Is it too full? Well some vehicles are equiped with a little hose that will let coolant out if there is too much or too much pressure, but not all vehicles will have it. (If you are talking about the overflow tank, if the radiator cap is leaking, check to see if the cap is in good condition)

Can you change your 1999 Pontiac firebird 3.8l v6 to a v8 LS1 350 Engine... and if so how... also will you need new trans or what else would you need?

Yes you can change them out. You will need new motor mounts and alot of other stuff just google search it to find out what all you will need.

How fast can a 2010 ss camaro go?

i ran my today on nice stretch of road and it governed at 155 at about 5400rpm in 5th gear

94 Ford Probe stalls at idle If started and throttle is applied it continues to run When driving and not applying pressure it stalls with and wo the clutch Fuel cutout light and check engine light?

YOU MAY WANT TO CHECK THE MASS AIR FLOW CENSOR. IT MAY NEED TO BE CLEANED OR REPLACED. ALSO MAKE SURE YOUR AIR FILTER IS CLEAN. if you really want to see what it is open the hood and have someone start it. Find the mass air flow sensor and as it is running tap lightly on it. If it straightens it out that is the problem if not i say go to the iac valve and replace it. That was a common problem with probes. The iac is called an idle air control valve and is usually around 60 to 80 dollars at autozone. ===================== The pins on the connector for the mass air flow sensor can become lax over time as well, causing the engine to not receive proper signals from the MAF. Take off the connector and push the metal connectors down so they apply pressure to the other side of the connection once it is plugged in again. Just something free to try first before buying parts. Also consider pulling the codes from the engine by jumping some test connectors in the engine compartment. Do some searching on the net, and you should be able to find out exactly how and what codes mean what. Check the main air intake hose as well, on the older model Probes at least, the hoses crack, and when gas is applied, the engine will move slightly, opening up the crack in the hose, and causing a massive vacuum leak. -Shaun

How do you disconnect the alarm of a gran Cherokee 1995?

I disconnected mine by unplugging the security module located under the dash. This is a small, approximately 3 inch square cube black in color with the words "security module" printed on it. It just unplugs and will disable your alarm and security system in the car.

How much would it cost to replace the transmission in a Chrysler LHS mid 90s?

$1500-2000 rebuilt. maybe less if junk"used"transmission the 90's lhs has a transaxle which is very expensive. i bought a used one for mine, it cost around $500 at a salvage yard and about 400 more to put it in your best bet is to get yours rebuilt if it is not real bad off about $1000

What color wires go up the steering column to the high beam switch on a 1986 Jeep Cherokee Laredo?

I broke the high/low beam switch on the steering wheel and don't want to take the column apart to replace it, I want to tie a switch in, which is legal for an inspection sticker so we can drive it again, thx. it would at least just help to find a free wiring diagram.

88 VW cabrio when warm has a fluxuating idle and then dies could this be a vacuum leak?

This problem usually is a victim of a massive vacuume leak. Usually from either the idle air control motor or, the fuel distrabution box itself.

How can you find do a Vin search on an old vehicle?

Copy the VIN number off of the dash, door jamb, or registration. Go to here: http://www.forabodiesonly.com/mopar/decode_vin.php

How get the starter off a 1994 camaro with the 3.4 liter v6?

theres two bolts that hold the starter in place and two wires that attach to the motor. Remove the nuts holding the wires and take note of where each go. then while supporting the starter remove the two bolts and it should slide right out as one piece.

How do you reset the airbag?

Here's a site that will explain everything you need to know about airbag lights and resetting the system. http://www.airbagsolutions.com/ This website gives you the procedure for diagnosing and resetting airbag lights. See if your car is listed here. http://www.airbagsolutions.com/vehicles_list.aspx On most vehicles, the airbag light should come on for @6 seconds, and then go off if the system is working properly. If there is a fault or a problem in the system, the light will remain illuminated, or flash continuously. If the airbag light does not work properly, some vehicles have an audible tone that sounds indicating a problem with the airbag light system. When the light is on (or the tone is sounding), the airbag will NOT deploy, even in an accident. The flashing light on your car is telling the answer you need. On some vehicles, the light is flashing a two digit code. Once you know the code, you can most likely repair it yourself. There are fairly easy procedures that most people are capable of repairing. Airbagsolutions.com has the fault code charts to tell you what is wrong and how to fix it!

Some vehicle manufacturers accommodate systems without a scanner (like Toyota, Lexus, Nissan, Infinity, Honda, Acura, Ford, Lincoln, Mazda & Mercury) and some require a scan tool. Check out these websites also for more info on airbag systems and the light. http://blog.airbagsolutions.com/archive/2007/11/18/why-is-my-airbag-light-on.what-should-i-do.aspx http://www.airbagsolutions.com/resources.aspx http://blog.airbagsolutions.com/ Also, you may want to check out this site for information on researching your own vehicle for factory recalls!!! http://www.airbagsolutions.com/nhtsa.aspx

How to change window motor on a 1997 camaro?

Pull off door panel. Roll window half way down. Un-bolt window. There should be four bolts on the door panel that hold the motor. Take the arm off the left on driver side or right on passenger. Then motor should just slide out of the hole.

What is wrong when the windshield wipers on a 1992 Town Car stick straight up when turned off?

It sounds like you are not turning the wipers off by using the wiper-switch, but are instead just turning off the ignition-switch. The result will be as you described. Try FIRST turning off the wipers with the wiper-switch, and THEN turning off the ignition-switch. Wrong answer , the question is when the --wipers are turned off- -they stop sticking straight up . not when the ignition is turned off . Delay wipers have a relay module under the dash and above the brake pedal. It's a black plastic box approx 4"x6"x1" with a connector on the short end. The park relay in that module is defective, but as it's on one circuit board, you have to replace the whole thing. it ran me $75 from Ford/Lincoln.

How do you find proof of ownership using a VIN or HIN?

A dealer for that brand of boat may be able to look it up for you. The fish and game service may be able to trace it down also.

Can a 2000 ss Camaro hood fit a 1995 z28 Camaro?

No. The 1998 to 2002 hoods are sculptured in the front to fit the restyled headlights.