0
Chevy Suburban
Chevy Suburban is Chevrolet’s large sport utility vehicle which started production in 1935 and is one of the most profitable vehicles of General Motors. The vehicle has also been manufactured under the Holden, Chevrolet and GMC brands.
5,970 Questions
How can the VIN be determined from a 2.5l Subaru engine number?
It can't. The the only thing that a VIN number has in common with the engine is the 8th digit of the VIN tells what type of engine it is. The VIN number though may allow the dealer to access the engine number from their databases.
Im not sure, but my 2001 Galant 2.4 GDI is doing the same thing. At first it wouldn't start. I cleaned the throttle body (severe tarry coke buildup) and replaced the high preasure fuel pump. Now it will start but revs up and down, and when the throttle is pressed fully wont rev higher than 3000 rpm. Sounds as though its hitting the rev limiter but alot lower......
Im going to replace the throttle body and MAF sensor next. Im also going to check the EGR valve incase it is stuck open. I will probably bypass the EGR valve altogether.
is it an auto? it sounds like if its an auto that the troque converter clutch is sticking and acting like a clutch in a manual trans when this happens its like never pushing in the clutch till the last second which causes it to nearly stall hence the drop in rpms and voltmeter readings as the battery attempts to keep motor running
How do you remove a stuck nut on an ac accumulator on a 1992 Chevy truck?
It is funny because I just did this last night. On the side of the accumulator that goes to the hose there is a nut that turns. If your accumulator screws right onto the coil at the firewall, you have to turn the whole accumulator as there is not an actual nut to turn. There are two nuts and a bolt to remove the brace. Make sure to disconnect your battery first as you will come close to the fuse block on the fire wall. Hope this helps.
What is the sensor called that is to the left of the thermostat housing on a 1994 GMC 5.7L V8?
That is the coolant sensor. Not the one for the temperature gauge in the dash.
Where is the oxygen sensor on a 1997 Silverado?
They are screewed into the exhaust pipes, They are about 4 inches long and have an electrical connector pluged into the end of them. I think there is 2 or more on that year.
There will not be any after the muffler.
The first thing I would look for, is too make sure their is no blockage,if it has a vent tube,the motor needs to discharge the air it is producing,the Second thing you said you changed the motor had the original motor been running for a longer period of time,I don't know what it is attached too, does it plug into a wall outlet or does it have a disconnect plug check the wiring to the motor, also check the voltage, there are all kinds of blower mtrs, and hook ups. make sure your connections are tight, any noise an impeller vibration
"Posterior tilt" means tucking the bum, ie: your pelvis is tilting/tucking and your pubic bone is forward (in a standing position). The opposite of this would be an arch in the lower back.
Where is the security module for your 1999 suburban?
It is located in the fuse box of your suburban's electrical system under the hood. If you are uncomfortable working with the fuses of your vehicle consult a professional.
When setting timing what degree are each of the timing marks?
The answer should be in your owner's manual in the last few pages near the back.
Where is the Starter located on a 1996 Infiniti I-30 automobile?
It is located underneath the air filter, at the driver's side. Therefore you have to remove that filter and its base while you are standing (the car need not to be jacked). I hope this would be helpful to you.
You have no spark on a 1994 1500 5.7 suburban?
There will be no spark on a 1994 Chevy 1500 5.7 Suburban if no power is getting to the ignition system. This can occur from a damaged wire, loose connector, or failed component.
How to adjust Chevrolet truck brake calipers?
On the disc brakes I've seen (not very many), the calipers are self-adjusting. When replacing pads, the caliper must be compressed to accommodate the new, thicker pads. Other than that, I haven't heard of a brake caliper adjustment.
Ans 2 - There is no adjustment necessary in Chev/GM front brakes. If they don't work as well as expected. the caliper slides may be very rusty. Scrub the slides with a wire brush then lube with a touch of dry graphite.
The grill below the windshield, right behind the hood, covers the wiper assembly. You'll have to figure out if the linkage broke or just came loose. Pull the grill and turn on the wipers. You should be able to see what ISN'T working. From your description, it's not the wiper motor, it's probably the shaft that drives the wiper arm. You will probably need to go to a dealer if you want a NEW one, but something like that seldom goes bad so you might want to consider a wrecking yard. It should be the same wiper assembly for suburbans and pickups. there are two types of windshield wipers that i have seen. 1. one motor and two motors. if one motor is controling both blade assemblies look for a rod that connects the two assemblies and one side of the rod may be disconnected. 2. Two motor- each motor controls each assembly for the windshield wiper. on this type look for 2 things a. look and listen for the motor on the working wiper and go immediately to the non working wiper and listen for the same noise if you hear the same noise then at the base of the wiper assembly (the rounded bottom of the wiper arm assembly) there is a gear that the motor fits into. this is probably stripper. Goto any auto parts store, most will show you how to take off the wiper assembly arm and turn on the wiper again. if you see the gear moving then tell the auto parts person you need the arm assembly that you or that person is now holding if the gear is not moving then you need the wiper motor and you should keep the assembly that you are holding. good luck
Where is the starter located in a 1989 Ford Probe turbo?
Open the hood and stand on the driver's side of the car, you should see the transmission. In the top right corner there are two 14MM bolts, your starter is back there, after bolts are removed, reach back there and disconnect the wires from the starter then pull it out. Shouldn't be too hard. Not sure on the automatics though.
Where can you find a radio wiring harness diagram for a 2004 Chevy trailblazer?
Join www.trailvoy.com
Posted in the resources section
Where is the location of blower relay on a 1999 suburban?
My owners manuel list the blower relay as being in slot 12 in the fuse box under the hood on the drivers side.
Depending on whether you have the towing package or not, about 7500. But really, they can pull just about anything you want to pull. I do not know how much they are rated for if your burban doesn't have the towing package. Probably 5000 or less.
Where is the park neutral switch on a 1987 Toyota Camry?
on '88 Camry 4-cyl, Neutral Safety Switch is in front, just behind radiator, on transaxle case. For an87 and better data, ask question with name of component, as above. good luck.
Answerhow to tell whether my 1987 Toyota camary motor is locked upWhere is the fuel cut off switch on a 1991 Chevrolet Suburban?
passengers side kick panel GM cars use a oil pressure cut off relay to disable the fuel pump. If the vehicle is involved in a crash, this cuts power to the fuel pump when it senses no oil pressure. There is a by pass circuit that will run the fuel pump for a few seconds to allow the car to start. If it doesn't start within this time frame, the pump won't re engage until the engine builds up enough pressure close the relay.
How do you change and where is the location of the Knock Sensor on a 1998 Mazda Millenia?
29S HERE, ONLY 97 AND 98 MILLENIAS HAVE THE EXACT SAME MOTORS. I HAVE A 97 AND I HAVE REPLACED MY KNOCK SENSOR WHICH IS LOCATED IN THE CENTER OF THE ENGINE BELOW THE INTAKE. IT WILL REQUIRE THE REMOVAL OF THE AIR INTAKE AND NEW INTAKE GASKETS YOU CANNOT REUSE THE OLD ONES.
What would cause a whining sound from the rear end of my 1997 ford explorer xlt?
need to know the year
That sounds like it could be a wheel bearing or main axle bearing.
What the difference between suburban 1999 25000 and suburban 1999 1500?
1500 is a 1/4 ton, 2500 is a 1/2 ton.
