0
Dashboard Lights and Gauges
The vehicle’s dashboard serves as its control panel, providing the driver with gauges indicating speed, distance, temperature and the amount of gasoline left in the tank. It also houses light indicators such as a seat belt warning light and an engine malfunction light.
4,781 Questions
How to you retrieve the fault code when the check engine light of a 98 Mazda 626 is on?
Since it is OBD11 it requires a scanner to retrieve the codes. Most parts stores will read then for free.
you can use a car scanner to clear it out.
You replaced the factory CD player in your 99 Mazda 626 now you have no dash lights how do you fix?
its because you blew the fuse on the illumination just swap it out.
same problem
What do all the ford ranger dash warning lights mean?
Check out ( www . motorcraft service . com ) no spaces
Click on Owner Guides
You can view the Owner Guides online ( currently back to 1996 )
You can see pictures and meanings of the dash warning lights
How can you find out what a warning light means on a 2000 Ford Ranger 4WD?
Owners manual. Don't have one then describe the light you are referring to. Red means stop, yellow means caution, or attention. Without knowing which light, I can't help.
What is the warning light with the exclamation symbol?
Normally this is a low tire pressure indicator. The exclamation point is shown inside of
what looks like a tire casing with tread on the road. It denotes a tire on the vehicle is 6 or 7 lbs. psi different than the vehicles' normal recommended pressure.
Why does the low fuel light come on when there is a full tank of gas left?
Fuel gauges are not completely accurate. You would seem smarter if you calculated your mileage using your trip odometer. It is not as difficult as it seems and you will have a more accurate method of gauging your fuel usage and knowing your gas mileage.
How do you fix a speedometer in a 1991 Ford Aerostar?
What exactly seems to be the problem? Do you have a digital speedometer or analog speedometer?
the problem most encountered with a bad speedo is the gear in the transmission tail cone housing. make sure it isn't stripped the other problem could be the speedo itself. If it's analog then somewhere in there it is stripped out. If it's a logic type then usually the pulse board is gone.
Why do both indicator lights flash and then stay on?
the oven indicator light stays on and the temperature light but i turn the oven nob on and the oven heat up then i turn off . it gos out tell the temperature cools down. then it come back 0n.
If the dash lights are out but the fuse is good on a Ford F-150 how do you fix it?
It could be the headlight switch, It has the dimmer inside it.
on my 1992 I had the same problem it drove me nuts. but there 2 fuses for it. the other one was for the warning buzzard it also says that it is for that so check and see if that is it.
1) operator error. check dimmer switch setting.
2) all bulbs faulty, check and replace as needed
3) bad (burned or corroded) headlight switch. expect taillights to be out, your question indicated this is not so
4) loose connection at electrical connector to helight switch. Try moving tilt column and wiggling connector
What does it mean when your fuel cut off warning light comes on?
Depends on what kind of car you have. Sounds like maybe the fuel is low. Or, if there is ample fuel in it, you may have a clogged line or pump. Or maybe your pump is going out. Feul is a relatively inexpenxsive problem for a shop to do it.
ground wire from tank to frame needs to be cleaned and remounted
Where is the rest button for srs light on a 1994 eagle summit wagon?
My shop manual indicates a special scan tool is used to read the fault codes. If the light is on it is indicating a fault somewhere in the system. This or these faults will need to be corrected for the lamp to go out. The same holds true at start up. If you have no light at start up for a few seconds, this also indicates a fault in the system. Try a Mitsubishi dealer if you have no luck with Chrysler. Summit wagons are re-badged Expo LRV's.
How do you change the bulb behind the heater control panel on a 1970 Mustang?
THIS DESCRIPTION IS FOR A 1970 MACH 1 WITH NO AIR CONDITIONING: There is a single globe that is located dead center on the back of the control panel and it is not easy to get to (impossible for most) by simply reaching from the underneath back side. In all reality - you must remove the heater-radio bezel and then remove the radio too. This will provide access through this radio opening to reach through and down to the back of the control panel housing. Slide both cable levers to full right otherwise their levers will be right on top of the bulb. The bulb is in a "wiggle & pull" globe holder and the wire from it has just a little slack before a wire clip anchors it down. This job definitely requires a mirror to be able to view this arrangement down through the radio opening before trying to actually remove the bulb holder to replace the bulb. The bulb holder holds the bulb inside a blue transparent housing that gives a blue hue to its night display. Replace it with the best quality clear bulb you can, perhaps even one of the new and brighter LED design bulbs.
If for some reason you are going to remove the entire heater control panel & housing, you'll need to reach in through the radio opening and slip both cable looped ends off the control lever end posts as well as disconnecting the wire connector for the fan switch. This connector is just a pull out connector with no hooks, but it can require a lot of force to dislodge it. The bulb holder (mentioned above) will also have to be removed because it's wire is anchored to the instrument panel frame and not the heater control panel itself.
Good luck and have some band aids on hand for your skinned knuckles when you're done!
P.S. - Its still worth it in the end to just have one of these impressive and highly sought after 1970 Mustangs ...probably one of the most desired years of all Mustangs produced. - a fellow "MuscleStanger -
Will a lower cold cranking amp on a car battery affect the idle speed rpm Mazda 2.0 sport 2007?
No. Battery cranking amperage has nothing to do with engine idling. There are a lot of potential issues from vacuum issues to ignition.
What is wrong when all warning lights come on in a 1988 Mazda 626?
All the warning lights are supposed to turn on for a few seconds as a "bulb check" when turning the key to start the car. Do the lights stay on after the car has started? If so, you could have anything from a faulty ground to a damaged computer.
What is the warning light looks like an exclamation point in a circle?
In the Chevy Aveo, the exclamation point warning light in a circle, means that the air pressure is low in one or more of the tires. This is per the owners manual.
What does the orange light on the far right mean on a citroen Picasso?
have a scan on it most probably come up with p0400 code get some redex to clear out fuel system if not work its something to do with the fuel system
It could be a simple missfire. Mine did it a few years back because of damp weather.
Citroen charged me £35 to diagnose the problem but couldnt tell me what it was.
It is back on now and causes me no problems. It is just an engine management fault.
If your worried get it checked out but be prepared to pay for it.
What do the warning lights on a 99 Saturn SC2 mean?
Which lights are lit? What do they say? There are many warning lights
The light come on when the system detects a problem and sets a trouble code. You should have it diagnosed by a trained technician. The airbag system is not for do it yourselfers.
Where can i find 1996 dodge ram van fuse diagram?
Try a Chilton's Manual at your local library, or another repair manual such as Haynes. They tend to be somewhat generic at times, but sometimes good in a pinch.
There are dealerships that will give you access to Mopar and other manuals online. Sorry, I can't recall how I worked it out with them, but had acess for a year or so to Mopar pictures, schematics, and su
haynes manual does not have fuse diagrams
