Low tire pressure
How can you reset your maintenance reminder light on your 1995 Ram 3500?
The SRI lamp may only be reset with the use of a DRBII scan tool, or equivalent. If this is not available, you will have to take the vehicle to a properly equipped shop for them to reset the lamp.
How do you reset maintenance light on 2011 Smart KEY rav4?
This is an easy task but it can seem confusing since you do not have a key to turn, like on other models. As you know, when you start your RAV4 with a smart key, you have to step on the brake pedal when you press the start/stop button before it will crank. To reset or clear the maintenance light, you will NOT put your foot on the brake pedal when you press the start/stop button. So, with foot OFF the brake pedal, press the start/stop button, you may have to press it twice to get the dash lights to come on, then set the trip button for the odometer to TRIP A mode. (NOTE: you do not have to hold the start/stop button, just press and release it.) Now press the start/stop button again to turn off the dash lights after you have placed the odometer to TRIP A mode. Next you will press the trip button and HOLD IT IN and then press the start/stop button to turn the dash lights back on. You will see the odometer display flashing dashes, just keep holding the trip button until you see 00000 and then it goes back to normal readings and the maintenance light is off. That's it. Hope this helps.
What is k engine symbol mean near speed meter on peugeot 206?
it is the engine managment light indecating a fault
Where is the speedometer sensor on a 2002 Ford Escort?
Your vehicle speed sensor will be on the transaxle somewhere. Go to Auto Zone's web site and use their component locator, that will take all the guess work out of it.
How do you reset the maintenance inspection light on 2003 vauxhall vectra?
Hold the break pedal down and the milometer trip button turn on the ignition whilst holding these in the service light will flash then resets
What are the Dashboard lights on 2002 Saturn L200?
I changed my dashboard lights (lamps) on my 2002 Saturn L200, it's not that hard. I put complete directions with photos here:
http://dl.dropbox.com/u/1347192/saturn/saturn200.html
The lamps are 2752MF.
You can buy the replacement bulbs from "www.memotronics.com". The link is their EBAY store. I used "miniature light bulbs 2752MF" from them, worked fine.
http://dl.dropbox.com/u/1347192/saturn/saturn200.html
I had this condition on my 1998 Grand Cherokee. I discovered that it was worn contacts on the headlamp / interior light dimmer assembly. I cleaned the contacts and it worked for awhile then the problem came back. I replaced the assembly for about $100 and the problem went away.
Answermy 97 limited did the same thing, as well as the headlights momentarily turning off (while driving) with the headlight switch switched to the "auto" mode -- bad contacts in the rotary knob and panel dimmer; ended up replacing the headlight switchI just had my 96 switch out took it apart found the soilder joints loose on the circuit board added a little soilder all better know. Had nothing to loose it was either do this or spend 100 bucks .
How do you change the dashboard lights in a 1996 Isuzu?
I own a 1997 Isuzu Rodeo and had the same problem. I went to a local Isuzu new-car dealer and was quoted a price in excess of $100 to replace the burned-out dashboard lights. I was told that the cost is high because the top of the dashboard has to be removed in order to obtain access to the lights. I did not have the lights replaced. carlpers
How do stop abs and asr lights showing on dash on a golf 2000 model?
chances are its either worn brakes or possibly a wheel speed sensor...good luck!!
What do the different symbols on the dashboard of a diesel 1994 Peugeot 405 mean?
everyone should have a manual for their vechicle, and the library should have a professional shop manual available in the reference section for FREE to make copies of--the PRO manual has more detailed info, and may have wiring diagrams when needed...read up and fix 'em like a PRO...good luck Dave :)
Check to see if parking and tailights are working - same circuit could be a blown fuse
Dashboard warning lights on a discovery?
what is this red light above my fuel gauge on my 2004 land rover discovery
How do you replace a speedometer cable on a 1989 Hyundai Excel?
Hello I have a 1992 HYUNDAI EXCEL..just changed mine..but its a standard shift..first disconnect the NEGATIVE battery cable..stops any airbag accidents..take pliers..DISCONNECT end at TRANI..run new speedo cable the same way the old one goes..pull out RUBBLER BLACK grommet behind DISTRIBUTOR CAP..this grommet stops water getting inside dash .Its under the hood inside firewall (behind distributor cap). NEXt undoes the 3-4 screws inside car that hold your plastic intrument gauges....pull out SLOW..behind it is WHITE plastic piece..SQEEZE together..this piece will release the old speedo cable..PULL this white plastic piece AWAY FROM YOU..it releases the old cable..its a difficult job..worse than u think, but it can be done..took me over an hour...the worse thing was trying to remove the WHITE plastic housing behind DASH guages..I was pulling it the wrong way..must be BACKED OFF away from you..GOOD LUCK
I would be concerned about the 4-wheel anti-lock (4WAL) braking system's "brain". It is called the electro-hydraulic control unit (EHCU). Take it to a mechanic you trust and ask them to pull codes. This is worth the money in most cases. If it is the EHCU it is going to be BIG BUCKS ($1000 - $1500 !!!) But if this is the problem and you don't fix it the brakes will just fail. The brakes wont fail Just the electronic side of the ABS The hydraulic system will work correctly with the ABS light on. If the light is on the ABS is in fault mode and is powered off, not working at all. No trouble! If the light is off it means the system is trying to work and may pulse the ABS pump
What does the exclamation point warning symbol on a 2005 infiniti g35 mean?
its the low tire pressure warning. check your tires
you've got a blown bulb somewhere, headlight, indicator etc.
What does the EGR light mean on a 1986 Mazda B2000 truck?
I don't know the specifics for a 1986 Mazda pickup, but EGR stands for "Exhaust Gas Recirculation".
The EGR light comes on at 60,000 miles and again at 80,000 miles. It is a way Mazda attempts to get you into a dealer. There are two wires one green and one brown, one of these two will be plugged into a white plastic connector on a single wire. (Under the dash at the far left) unplug the green or brown and plug in the other wire. Problem solved, start the engine and the light will go out.
Ron
AnswerThe EGR valve recirculates exhaust gas to reduce combustion temperature and NOx emissions which are formed under high heat. The EGR system does not lower HC emissions.How do you turn off the maintenance required light in a vehicle?
Or you could always try doing the maintenance, I bet that would turn it off.
Put the key in turn it on "BUT" don't start then pump the gas 3 times kinda fast. This works on GMC 2003 SUV's
What does ETS mean on a 2002 Grand Am GT?
ETS on a GT means Enhanced Traction System (ETS) or Traction Control.
On a 93 3.4 l v6 camaro what does the abs inop light mean on the dash?
ANSWER
Check to see if you have a rear brake light/taillight out. If so...replace the bulb. My 94 had this problem and the cruise went out and the light came on...replacing it fixed it
Answerantilock brake system inoperable. If your lucky, you just new brakes and/or rotors. Can also be deeper like speed sensors or electrical problems.Thanks, I also had the abs inop light and no cruise and ckecked spoiler brake light and both were out fixed 94 chev camero z28 350 Thanks Also had before no cruise and no a/c went to the dealer could not fix but said to try to replace the computer, I sanded the pins on the computer as a last resort with very fine 400 to 1000 grit ok everything worked perfect. If all fails sand pins on ecu
Why wont your speedometer work on your peugeot 306 even though you have replaced it?
you replaced speedo, so try replacing speed sensor