0
Ford Bronco II
The Ford Bronco II, a smaller version of Ford Bronco, is a compact SUV produced from 1984 to 1990. The Bronco II offers optional 4WD, mechanically identical to Ford Ranger, but does not have a removable roof.
1,174 Questions
Where is the tire jack and wrench located on a 2001 Toyota 4Runner?
The tire jack is located under the back passenger seat. There should be something to pull the seat up with.
1989 Bronco 2 idles OK no power on acceleration whats up?
Once you rule out some kind of ignition problems,; spark plugs and wires, ignition timing, distrib. cap & rotor, the cause may be low fuel pressure from a failing pump or clogged filter. Listen to the pump in the gas tank. If its been getting louder lately, have the pressure tested.
Answer
i would also check the oil for radiator fluid or at least keep an eye on it cause a loss of power could also be a blown head gasket
Also check fuel psi regulator remove vacuum line check for fuel leak should be no fuel replace if leaking. FPR controls psi going to injectors low psi low power also make sure you have no vacuum leaks FPR uses vacume to adjust fuel psi.
What is the purpose of vacuum lines in auto engines?
Engine vacuum can be used to operate all kinds of devices in your car, from vacuum modulators in the transmission to the devices that open and close the doors for your cabin heating and cooling. Vacuum lines are the tubes that deliver the engine vacuum to those devices.
It depends. I've jammed my fingers over 20 times. the last time i did it it bruised and i can't remember any other time it did. So it all depends on how you do it and how badly you did it as well.
Those codes are for a fueling problem and a failed engine computer. You may need to replace the computer.
Will a late 70's Ford 400M truck engine fit in a 68 f100 where a 390 was?
yes but will need to change motor stands and move them back an inch or so and you will have to cut your drive shaft, i know this because i have a 351 c in my 1968 ranger short bed
How do you fix a 1989 Ford Bronco gas gauge?
The sender is in the fuel tank and requires you to drop the tank as that is the only way to get to the hose and wires.
Where is the ignition switch on a 85 Ford Bronco II?
You must first remove the steering column covers. Once they are out of place you will see the actual ignition switch located on the RH upper portion of the steering shaft area. Remove the plug in from the switch by lifting up on the clips at either end of the socket tabs and wiggling the wiring socket free from the switch. To remove the switch, first take a punch and hammer. Center the punch on the head of what looks like a rivet and strike it firmly a couple of times with the hammer. Then using a good pair of pliers, or preferably a pair of vise grips clamp the jaws firmly and unscrew the mounting screws that hold the switch to the column in place. The installation is just reverse of the removal procedure, other than you don't have to strick the screw heads once back in place, just be sure they are tightened securly. When putting the covers back over the column, be sure to install the upper one first. It won't go on no matter how hard you try if the bottom half is installed first. Believe me, I just changed mine out this last week.
:-)
What determines an object will sink or float?
The Density of the object as long as its .99 grams then it will float because the object has to have less density than water in order to rise above the water.
On a 86 full size bronco is tailgate dash switch hot at all times?
It shouldn't be. It was designed to only operate once the key was turned on.
How do we decide if an object floats in water using density?
If an object is less dense than water, it will float. If it is more dense than water, it will sink.
What is the transmission fluid for 1988 ford bronco ii?
Look on the dip stick, it should read use only mercron. I know it call for type F, but make sure it has mercron on the lablel. I made the mistake of having my transmission flushed and the service man put the wrong kind in. When I went to pull a small lawn mower trailer the fluid sprayed out on the rear of the Bronco. Hope this helps, Wayne
What is the windshield wiper size for bronco II?
Wiper blade sizes may vary by year so you need to lookup the exact year of the Ford Bronco II. See sources and related links below to lookup wiper blade sizes by make, model and year.
Where is the distributor hold down bolt located on a 1987 Ford Ranger V6?
if the distributor is in the back of the engine it will be hard to see. so you might have to stand on the bumper and lean over the engine, it should be at the base of the distibutor where it meets the housing. if you feel with your fingers you will find it. sometimes it requires a special wrench to get at hard to reach angles and sometimes not . you'll be able to figure it out,just be carefull if you have the motor running.
What is the psi for a 1989 ford bronco?
Look on one of the tires for a MAX PSI number and inflate them to less than this number.
How do you repair the brakes on an 86 Bronco II?
Break repair is a big task. First identify where the problem is. It could be the pads, the light wiring, shims, calipers or rotors. Disassemble the system using the manual and diagnose the problem.
Where do you find the fuel pump relay switch in a 92 Dodge Dynasty?
It should be located on the driver side fender... 2nd relay back (because theres a row of relays in that panel) I heard that you can switch the fuel pump relay with the horn relay and if the vehicle starts and the horn wont work then the relay is bad.
What is the firing order for 1986 ford bronco 11 2.9 l?
1 - 4 - 2 - 5 - 3 - 6
The distributor rotor turns CLOCKWISE
The engine cylinder / spark plug locations are numbered :
firewall
3 - 6
2 - 5
1 - 4
front
Where is the 4x4 control module located on a 1988 Bronco?
It is located under the grill on the dash of the vehicle. It is held in place with Phillips head screws and you will need a very short screwdriver or a ratcheting bit.
A picture of a 1988 Bronco II 2.9 liter 4X4 XLT wiring diagram?
check autozone.com they have alot of free referance material online Answer: Try this site. They have alot of info on Bronco ll and Rangers. http://www.therangerstation.com/
What years do ford broncos' top come off?
The Bronco's design was intended to have the top come off so every year bronco's top can come off but they only make soft tops up to 77 for the bronco so before you try to take yours off think about getting a custom made one or the seal of the roof wont be the same.
How do you reset the computer in a 1988 Ford bronco 2 has new battery and still no power?
the bronco needs to have the ground wire connected from the battery to the body. if you replaced the battery and disconnected that ground it simply won't start.
How do you replace headlights on a Ford Bronco 2?
If it is an early bronco, the easiest way is to remove the grill. There are approximately 8 screws around the grill. This will let you get to the retainer screws and the bulb just plugs in. This is the suggested way from the better repair manual for the broncos. If it is the later bronco, there is a retainer on the back side of the headlight shell that can be turned about a quarter turn to release the bulb, it is separate from the headlight reflector. You might have to remove the battery or reach down along side the washer reservoir to reach the retainer, and if the bulb hasn't been removed for awhile, the retainer might stick. The retainers have been known to break, they are plastic and do run hot, but they are available at most car part stores.
