Ford Mustang

It all depends on which Mustang you are talking about. The 2011 GT500 is reputed to have a top speed of over 160 mph!

I'm pretty sure they never put a v6 in a fox body. thy had the 5.0 302 and the 2.3 4cyl that came in the lx cars.

With an 02 sensor wrench. You practically have to put the car on a lift and if you're not careful you could strip the sensor itself or the "bung" in the exhaust pipe. I would recommend having it done by a mechanic or atleast have them show you before attempting to do it yourself.

Yes, Mustang wheels will fit other cars. For a better answer than that, you could be more specific with your question.

Aluminum, and bulletproof glass.

Since this question is in the mustang section, I assume you mean a 3.8 not a 3.9.

The 3.8 was rated at 190 horsepower from 1999 to 2004. The anniversary model didn't affect the power.

Actually since they are in the mustang section, i assume they did mean the 3.9L. It is an optional to the 3.8L. And the HP is 193 stock same as the 3.8L.

the starter is located on the bellhousing towards the passenger side

A malfunction has been detected with the Anti - lock Brake System , as long as

your red brake light is not lit up in your dash you still have " normal " brakes

It could be a fuse , a sensor , or some other problem

2000 gallons.

The 1995's are rated at 225 HP

There are many places one can purchase a Ford Mustang GT. Auto Trader is a good place to find this model of car both new and used. The website 'CarCurus' also sell the Ford Mustang GT or one could purchase it directly from a Ford dealership.

Check under the car in the back by the gas tank - that's where it is on my '99.

Bank 1 is the passenger side of the engine in your Ford Mustang ( V6 and V8 )

That is one of the heater hoses where it connects to the heater core. The heater core is located inside the passenger side firewall. There are two heater hose connections, an inlet and an outlet. Replace the hose with the appropriate size and attach a new clamp to secure it. Before attaching clamp, make sure you clean off any debris or corrosion to ensure a secure and leak free fit. After replacing hose, be sure to refill radiator with the proper mix of antifreeze (usually 50/50) or purchase a pre-mixed solution. After filling, run engine and continuously check coolant level. Never open radiator hot! Re-checking of coolant level and opening the cap several times during a few minutes of engine run time will help bleed air out of the cooling system. Air in the cooling system can cause hot spots in the cylinder heads which can lead to overheating.

Bank 1 is the passenger side of the engine on your Ford Mustang

Sensor 2 is in the exhaust after the catalytic converter ( downstream )

A 302 will fit with no modifications. I believe it is possible to shoehorn a 351 in with some mods.

According to the 2011 Ford Mustang owners manual , the fuel filter is a

lifetime setup that is integrated with the fuel tank and no maintenance or

replacement is required

The 3.8 liter ( 232 cubic inch ) OHV - V6 engine

( also , the 4.6 liter / 281 cubic inch SOHC V8 engine in the GT )

A mustang is one of the feral horses that inhabit much of America. (It is incorrect to call them wild horses as they are not truly wild; they are the descendants of horses belonging to Spanish settlers which have become feral.) A group of horses is called a herd.

No they are two separate company's.

Bank 2 is the drivers side of your Mustang 4.6 liter

Sensor 1 is between the engine and the catalytic converter ( upstream )

Sensor 2 is in the exhaust after the catalytic converter ( downstream )

Depends on which gt you are talking about. A foxbody gt can weigh as low as 3000 lbs where as a 2010 gt can weigh as much as 4500 lbs.

The 2013 Mustang's 5.0 Liter will get about 5-10 more HP, while the V6 will probably remain the same. Mostly styling tweaks and the automatics will have steering-wheel-mounted paddle shifters. The 2013 GT500 will have 650 horsepower as opposed to 550 which make the new GT500 go 200+ MPH

Yes