Usually when the lights will not come on, you have to jostle the machine back and forth a bit till the transmission clicks into position. Some times it takes several attempts to get the shifter and transmission to accept the Park or neutral position. If that does not work, then I suspect that adjustment is needed. It appears to be normal for the position to be a bit tight.
Why would an engine lose most of its acceleration power after about 15 minutes of driving?
I had the internal ceramic grid in the catalytic converter disintegrate into small pieces and go into the muffler. It would drive about five miles and then the check engine light would come on and loose power. It was a bear to diagnose.
Does a tub overflow valve prevent ALL overflow?
It may not, but it should. The International Residential Code gave this clarification: "Yes. An overflow is required to remove displaced water when a bather enters the bathtub or to protect against accidental flooding resulting from an unattended filling operation."
Most tub drains lead to the same outflow pipe as the bottom drain, so if the pipe has a blockage, it will do no good. Also, the rate of flow of water into the tub can exceed the ability of the over-flow drain to keep up.
How do you change headlight bulb in 1999 VW Jetta?
You will need to remove the front grill and the whole front bumper to access the headlamp housing. It's quite easy once you've done it.
Where can i find detailed 1990 ford ranger drum brake assembly diagrams?
autozone.com has great detailed listings jody goodyear tire and rubber
Why would a brand new radiator be leaking lots of cooolant and smoke coming from under the hood?
I would start with checking all the hose clamps and hoses to make sure they are properly tightened and not damaged. Also check that the thermostat housing is not leaking along with the water pump. Especially if any of these were replaced when the radiator was replaced. Also check to see if drain cock is closed. Also make sure the overflow hose is correctly routed to the overflow tank. You might just have to run the engine and open the hood and see where the leak is coming from. Good luck.
Do you mean no crank/no start or crank/no start.... to put it simply, does the engine turn over?
Where is oil pan drain plug on 2004 Ford Ranger?
the oil drain plug is on the oil pan. crawl under the truck, it's on the very bottom of the oil pan. Closest to the ground.
What is the firing order on the 2001 2.3 4 cylinder Ranger and where does it begin?
firing order is 1342. number one cylender is closest to the radiator and the fourth cylender is nearest the fire wall jody goodyear tire and rubber company
What would cause the clutch to be stiff and not go in gear on a 1997 ford ranger?
your syncros might be worn or the shifter might need a new plasice ball on the end or the whole shifter needs rebuilt
What is the engine size in cc for a ford fiesta 1.1 liter engine?
it is a 1.3 litre which is 81 cid
1.1 litre = 1,100cc
What is the location of the camshaft position sensor on 1997 Ford Ranger 3.0?
near the firewall just left of center (or just towards the passengers side). it is located where the distributor would be on an older motor and is driven in the same manner. It also drives the oil pump.(not the sensor on top but the shaft below that is spun off the cam)
Missing fuse diagram can someone list the colors or fuses?
The fuse diagram for my 91 Capri is as fallows: Engine 15A Stop 20A Power Window 30A \ Meter 10A Hazard 15A ------ HTD B-light 20A Cigar 15A Tail 15A IG Relay Room 10A door lock 30A Audio 15A \ Fog Lamp 20A Air Cond 15A ----- \ Cooling Fan 20A Wiper 20A Heater 30A The IG Relay and the Heater are the big ones on the side of the fuse box.
Why do rear brakes freeze up when cold on 1989 s 10 truck?
If you mean that the rear brakes won't work or that the parking brake won't release, it's probably because they are wet and the ice is keeping the parts from moving. If it's the parking brake, dry everything out then lube the cable. If the rear brakes aren't working, make sure the brakes are dry when you park for the night.
its happen because heater core have too much durt insaide and you can clean it with some blowing thing or replace
How do you install a front bumper on a 98 Ford Ranger?
Oh yea I've got the bumper, lower air valance, and left and right mounting brackets. I don't have the bolts or anything, nor do I know how the brackets are supposed to mount.
There should be screws that screw the bumper to to inside of the valance. When your looking at the front of the truck you see the outside of the valance, but the bumper is screwed in behind the valance and the bumper is attached to the mounting brackets on the frame of the truck.
Do you have to have a special tool to remove plugs from a 2004 Crown Victoria?
No, just remove the coil, and use a spark plug socket.
Oil drain plug torque for 1996 Ford Ranger?
10 Lb-Ft or 14 Nm. Source: 1996 Aerostar, Ranger, Explorer Workshop Manual from Ford
Will a 1999 ford ranger bed interchange with a 1994?
Yes, as long as the beds are the same length. They come in 6 and seven foot lenghts. If you have a regular cab its 7, extended cab is 6. Also, if you have a full size bed and swap to a stepside, you will need the shorter gas filler tube from the Donner truck.
How do you replace the mirror switch on a Mercedes W210 E class?
You have to buy the complete lower switch assembly, because the mirror switch is not availble seperatly. Remove the shifter knob by twisting the lower portion loose. Then pull straight up to remove the knob. Next just pull up on the front of the wood trim holding in the switches, this will release the wood trim assembly. The switch group is held onto the wood trim with 3 slide connections. Just slide these back and remove switch group.