What is the cylinder order of a 1984 Chevy Celebrity 2.8L?
the number one cyl is in the rear pass side not the front like the rest of gm products
Will an 8-cylinder Ford transmission fit on a 1994 6-cylinder car?
No! The transmitions are totally different and maybe even opposite. It will not work at all!
How do you turn on the heater on a 1973 Volkswagen beetle?
I think. it would be the knobs on each side of the parking brakes(if they are still there in that year) pull them both up (i think) while the motor is on and you should get warm air to come out. You probably CAN'T turn it on, unless:
the heater boxes, which are sheet metal pieces wrapped around the cast-iron exhaust manifolds, are intact
the control levers on the sides of the heater boxes are there, the butterfly valve they control is there, and the cable running to the lever is there, intact and connected at both ends
the hoses connecting the heater channels to the heater boxes are there and intact
the heater channels don't have any holes in them
and even if all that stuff is right, you STILL don't get much heat out of them!
Where is coolant temperature sending unit located for 1995 Pontiac firebird formula?
located on left side of water pump
How do you know if ball joints are bad on 2003 jeep liberty what sound will the ball joint make?
Well I recently found out. I have a 2002 jeep liberty and they will make a grinding noises when you turn the steering wheel. The noise is worse when you turn at slow speeds or while in park. The noise will get worse over time. As the driver you'll know something is seriously starting to go wrong because the sound is loud.
How do you remove the quick connect on the transmission line?
there is a tool yo do it or you can use a very small screwdriver to pull the retaining wire out. be carefull not to bend it so much that it permanitly distorts. then the line just pulls out. all the wire does is hold the line in place there is a bulge in the line that it catches on then an o-ring that makes the seal. one last note if you have to replace the transmission fluid use atf+4 or you will destroy it.
How do you replace universal joint on front axle of a 98 dodge ram fwd?
take the wheel off take brake caliper off take spindal nut off pull axle out. I had to burn my old u joint out with a torch and I have a 2001 1500. I hope that helps you.
How do you troubleshoot the signal lights on a 1992 Ford Ranger XLT?
If none work: Check fuse Replace flasher Check with on column If only one out check bulb and socket
What is the standard tire size on a 1998 GMC Jimmy?
per vehicle specs on a 1998 gmc jimmy 4x4, the correct size tires are 235/70/15
Will low oil cause a no fuel pressure in a 1994 saburu?
Yes. The fuel pump is electric and if the oil pressure is low there is a protection circuit that will cut electric power to the fuel pump. Almost all newer cars have this feature. So, just add the proper amount of oil. Turn the key on for about three seconds before you try to start it (you may be able to hear the fuel pump run) and if you have oil pressure when you start cranking you should start right up. If not, you are going to need a mechanic to help determine the problem.
Why does your Ford Ranger suddenly cut off?
i had the same problem with my 90 ranger just suddenly cut off and won't start back or would start but ran awful it was the chassis ground broke
Need to remove headlight lens cover have moisture inside on 1993 Ford ranger?
I detail headlights at used car dealerships and what I do is drill a TINY hole on the lower edge of the headlight to let the water out. The heat from the light bulb will eventually dry it out. To clean the outside of the lens I use a product called CrystaLenz, this stuff really works great. Check out their website www.CrystaLenz.com for more information. ==Answer == You can also dry the lens out by talking the bulb and socket off the back and inserting a dry clean rag or towel through the opening and clearing the lens from the inside with a long object like a wooden stick. Once a hole is drilled, moisture can re-enter of course if not plugged with something like silicone. I have had the same problem.
fuse box cover
What is the timing degree setting for a 1970 318 4bbl engine?
1970!!! Geez... "0" degrees I think. Better call your local auto parts dealer and ask to be sure.
Fuel pump located on 1987 grand wagoneer?
The location of the fuel pump in on the drivers side of the motor. When standing in front of the motor looking at it, it will be on your right side up front. If your looking the carb, there is a fuel line near the bottom left side of the front of the carb, that runs toward you, the front of the motor, and then curvs down near the distributor. That fuel line is coming from the fuel pump going to the carb. To replace you will need two line or open ended wrenches, and remove two bolts that hold the pump in place. Very easy to do.
Do you have to remove exhaust to get to spark plugs on a ford ranger?
No- but you do have to be ambidextrous. My 93 Ranger is a bear, so I always replace with the best plugs I can find. Having different lenghts of socket extensions is also a must.
Where is the relay box 1 located on a 1996 Ford Ranger?
Under the hood in the engine compartment near the firewall on the left side.
Do you need a wiring harness converter for the 2004 Ford Escape 2wd no factory trailer option?
are you sure that your escape is not a 2003 model?
Where is the restraint control module located on a 1997 Escort LX?
Under the center of the dash, on the floor forward of the center console. Remove the trim panels at the very front of the console, by the gas pedal, and on the left side of the passenger's footwell, and you will see it.
What is the Tire size on 1968 Ford F-250?
i have a 1968 ford f250 high boy its stock tire size is 235/85/16 but it will clear 35 inch tires or some 285/75/16