Ford Transit

in the glove box behind the main fuses its on hinges and there are two clips ether side of it unclip then pull towards you gently and there are a few fuses there forgotten the number thoe sorry

The 2013 Ford Transit-Connect has 16 valves.

Refers to shipments that may yield methane gas. So to avoid possible explosion's. The term T I H S was used which stood for store high in transit. which allowed the methane gas to vent. Sorry i had spell the acronym backwards.

65litres

olive oil

crank seal

Yes the MK6 Transit is OBD2 and the port is jus down below the steering wheel

been looking for ages, reckon its a myth

turn ignition on in van, but do not start. press brake pedal and accelerator pedal at the same time. after about 30 seconds light with spanner will start to flash. turn off ignition. by doing this it resets warning lights. start engine, should be ok now.............cheers Michael

yes

A transit bearing is used for

1. Obtaining the compass error

2. Can be useful during course alteration points in areas of heavy traffic density

3. Transit bearings can be used as leading lights

4. Can be to check if a vessel is dragging anchor.

5.Gives us a position line

5 1/4"

The height of the 2015 Ford Transit-Wagon is 6 ft. 11.5 in. (83.5 in.).

When someone is arrested on a body attachment, "transit" typically refers to the process of transporting the individual from one location to another, often from a detention facility to a court or another jurisdiction. This can occur when a person is being moved to fulfill a legal obligation, such as appearing for a hearing or serving a sentence. The term indicates that the person is in between locations as part of their legal proceedings.

yes you do have to set the tappets

I'm almost sure it can carry 1.6 tonnes but check your weight plate in the foot well.

9 times out of 10 its because of the side door there is a little black switch on the door that pops out when the doors open and back in when its closed this tells the locking system that its not locked so it re opens the doors

try uncliping the switch and locking this should work Another problem that causes this is a broken earth wire to the door locking motors both front and the rear doors,it doesnt seem to matter about the side door.

How do you override ford transit deadlocks?

My 2005 T280 has a cam chain

The Vin numbers on a 2000 Mitsubishi Galant are located in two separate places. One is located on the drivers side door and the other is located on the top of the dash under the windshield.

To reset your Ford Galaxy Service inspection light. 1 Ensure ignition is switched off.

2 Press and hold the trip meter reset button whilst turning on ignition..

3 Hold trip reset until four dashes "----" appear in display and then release the trip button.

4 Turn off ignition.

Sometimes this procedure has to be done two or three times depending on whether it is a LN1 service, LN2 service or OIL if it's time for them all, then you need to repeat three times. On some models there seems to be a debate about opening and closing the bonnet before this procedure, some say the light comes back on after 1000 miles some say there's hasn't come back on yet and they've done 2000 miles. I think the best thing to do is not open and close the bonnet and see what happens