Fuel and Engines

the simplest engine that is made up of a burning chamber and a nozzle is a rocket.

An over head cam engine commonly called (OHC)

Airplane engines use jet fuel.

Read more, below.

As any 4 stroke engines, it depends on the amount of cylinders it has although it is commonly said that "2 stroke engines do not have valves", this saying mainly applies to out boards, weed eaters and these types of engine, but some GM engines such as the 671s and some others do carry valves.

Depending on year and model of motor. : You will find the contacts either under the fly wheel or there will be a pick-up on the coil.

The energy produced by the engine is mostly used to power the car, but due to an imperfect design, some energy still remains in the form of heat.

I would suggest using Google to find this answer.

but a quick summary would be:

disconnect battery

remove all wiring connected to engine

drain engine oild

drain radiator fluid

drain tranny oil ( if comming off as a separate peice)

remove intake

remove all house connected to engine

Unbolt all the engine mounts and tranny mounts

using an engine lifter, hoist the engine out of the engine bay

repeat the steps backwards to install engine

don't forget to replace all the engine fluids that were drained!

That depends on the vehicle it is in. Could be anywhere from 15 to 50 mph.

You will stop the engine, but the PWC will keep going forward and you will have no control over the direction in which you go or the speed you travel at. It's not a good idea in busy areas.

alot off people dont understand that the 1.6fsi engine should be ran on high octane for it to work how it should...

I GOSE BB BBBBBB BBBBB boo

The 3.7L has more cc's and slightly bigger cylinders with piston heads than the 3.5L.

bad injecters bad glow plugs

You can run out, and you have to take it with you.

Four

Depends on what year LS6

The 1970 LS6 454cid was rated at 450hp/500 lb-ft. Actual hp was around 500.

The 2001 LS6 produced 385 bhp (287 kW) and 385 lb·ft (522 N·m), but the engine was modified for 2002 through 2004 to produce 405 bhp (302 kW) and 400 lb·ft (542 N·m) of torque.

Upper left on the engine block

It depends on the extent of the rebuild, and if any optional upgrades are chosen by the owner. At the time of a engine overhaul, it's much easier to install parts that might be nearly worn out or to upgrade to better parts. So, there are a lot of decisions to be made and they all affect the price of the job.

Also, an engine rebuild could take place with the engine IN the truck (called an "In Frame") or the engine could come out for the rebuild (an "Out Of Frame") If the engine stays in the truck, the "In Frame" might cost $16,000 to $20,000. An "Out Of Frame" rebuild might cost $35,000 or more.

2000 vw beetle 2.0 head torque

that sound is caused by hot air causing the metal pipes to expand.

Pinging is caused the exhaust valve closes before all the exhaust gases are out and the intake valve opens and new fuel enters. One of the best ways to fix it is to adjust your timing, or change your fuel octane to a higher one.

This would require the modification of the exhaust system. The sound of any vehicle comes from the exhaust and not really the engine. A deep "throaty" sound is achieved by streamlining the exhaust system. This will also increase horse power because the engine won't have to work so hard to push the exhaust out thus more power is available to push the truck. If you have no knowledge of vehicles then exhaust modification should be handled by a pro. Keep in mind that some States have emission laws and there are always noise laws to consider as well.

The first running prototype was completed in 1957

Single overhead camshaft

Normal operating temperature is 212 F ( 100 C)

Syntetic oil is good until 260 F, mineral until 240 F