0
Honda Civic LX
The LX is a rebadged sixth-generation model of the Honda Civic. It was previously available only as a four-door car. It features 14-inch wheels, power locks and windows, front stabilizer bar, power steering, cruise control, cargo area light and a tachometer.
2,709 Questions
Where is the ECM located in a 1997 Chrysler Sebring LX?
when looking from the front of your car into the engine compartment it is to the right of the air filter on the left of the engine fuse box that is below your positive jump start post.
Why do my back speakers sometimes work and sometimes don't?
i have the same problem on my 2000 gtp i thought it was the factory radio but i changed it now im searching for the location of the factory amp do you have any suggestions?
How do you purge the cooling system for a 1999 Honda Civic?
Make sure engine is cold then do the following:
- Open radiator cap
- Start engine
- Once the thermostat opens , air bubbles should come out of the radiator neck
- Wait until air bubbles stops coming out of the neck
- Once the Air bubbles stops from coming out , fill radiator as neccessary
- Replace cap and test drive
- Repeat as neccessary
- Process can take long more than 10 minutes or more depending on how much air is trapped in the system.
How do you change the timing belt on a 99 Honda Civic HX?
Here are a few tips to get you started, the complete overview can viewed by following the link on Honda Man's bio page.
1. While working on engine only rotate it in the direction it turns while it is running (counter clockwise on most Honda engines), valve damage may occur if turned in wrong direction
2. You will need two 1/2" breaker bars, one to use with the crank pulley tool & one to loosen the crank pulley bolt
3. Start disassembly with the engine at top dead center. In addition to using the factory marks you may find it helpful to make your own marks with white touch up paint or white out (especially if the belt you are changing is for maintenance)
What does diagnostic code p0135 mean on a 1997 handa civic?
O2 Sensor Heater Circuit (Bank 1 Sensor 1)
Where is the ECU on a 1991 Honda Civic DX and how do you replace it?
It's on the front passenger floor board....Disconnect Negative battery terminal. Remove the carpet from the top. Remove the ECU cover. Remove the ECU retaing screws. Disconnect the connector and pull out the ECU..........Installation in reverse.....
Most likely this is a weatherstripping problem, check the seals around the door and windows for damage or severe cracks. If there is coolant in the pooling, then you have a heater core prob.
Where is the fuse for the tail lights in a 1997 Accord LX?
The fuse is located either in the fuse box under the dash, or on some, out under the hood. The box covers usually have the identification of what the fuse and breakers are used for. Look in the owners manual. It too should have the location, and labeling of which fuse protects which circuit.
How do you replace the front turn signal bulb located on a 1999 Honda Civic?
Turn the wheel to the left if changing the passinger side bulb and to the right if changing the drivers side bulb. Remove the pop out plug holding on the plastic wheelwell cover, reach in and turn the bulb holder a quarter turn, replace the bulb and re-assemble.
What is the rear track of the 2002 Honda Civic?
The rear track of the 2002 Honda Civic is 4 ft. 9.9 in. (57.9 in.).
Where is the water pump located on a 1992 Honda Civic?
The water pump is driven by the timing belt on the driver's side of the engine. You have to remove the timing belt cover to see it. It is secured by 4 (maybe 5) 10mm bolts. While you're at it, I would replace the timing belt.
All very true -- but first
Go ahead and borrow a 3/4 inch drive impact wrench and have it ready , go ahead and buy the pump, belt, and head cover gasket kit before you get dirty.
I would start by jacking up the left front and removing the tire and splash shield (15 min.) this also gets the car up in the air so it's not so hard on your back to bend over all the time working on it. Then remove the cruise control actuator and lay it on the induction system (no need to remove hoses). The darn electrical connector was tough to get off so just be patient and you'll see how to take it apart. (10 Minutes) Then remove the power steering pump and reservoir and lay them near the cruise control box. You'll need to pull the hoses off the reservoir and that will make a nice mess. Also remove the mounting bracket and the belt tightener (90 minutes as I had to heat 1 bolt red hot with the accetelyne torch to get it off))
Then take off the alternator belt (that caused the most blood loss for me (fat arm, tight space)) Then remove the head cover. (5 minutes) and the upper belt cover ( 2 minutes). Now take your 17 mm impact socket on your 3/4 inch drive air impact wrench and remove the big pulley through the wheel well. (1 minute) (or you can screw around with breaker bars, rubber straps and your 1/2 inch electric impact wrench for 4 hours and then go borrow the 3/4 inch BAD BOY). Now remove the 3 bolts holding the bottom cover and you are in!. I went ahead and lined up the timing marks before removing the timing belt but really, as long as you are very careful not to move either pulley with the belt off, you will be fine. loosen the tightener pulley nut and remove the belt. NOW you get to remove 5 easy bolts and put on the new pump (easy as pie). Reverse the procedure to get it done ( Use a 5.231 second burst from your now ashamed 1/2 inch impact wrench to reinstall your big pulley at the required 135 ft-lbs torque) DO NOT USE THE BAD BOY! Add 1/2 gallon of antifreeze and top off with water. I had a ball! and hope you do as well!
Why does a 1991 Honda Civic LX exhaust smell like rotten eggs?
Malfunctioning emissions system. Get this repaired. Engine probably running rich from a leaking fuel pressure regulator. If there is fuel in the vacuum line the regulator is bad.
Where is the main relay located on the 1994 Honda Civic DX?
under the dashboard on the drivers side right next to the hood lever
tighten or replace your cap
How do you replace window crank?
Most window cranks are held on with a clip behind the face of the handle. It is shaped like a U with the sides pinched in a bit. There is a tool available to push the clip out that should cost around $5 or you can bend a hook on the end of a nail and pull it off. Push in on the door panel and you should be able to see the clip.
How do you turn off the maintenance required light for a 2004 Honda Civic Lx?
If you have done the required work to correct the problem, all you then have to do is remove the battery cables from the battery, wait 10 seconds then replace them. This will reset the check engine light. The above answer is incorrect. Removing the battery cable will not reset the check engine light. This must be done with an OBD2 scan tool. You said maintenance required light. Are you referring to the light that reminds you to change the oil. If so, you can reset this light according to instructions found in your owner's manual.
How do you change starter on 1994 civic ex?
Starter replacement step by step; http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c15280061854
Does a bad PCV valve cause jerking in engine?
Check your motor mounts and what your at it check trans mounts.
How do you change the brakes on a Honda element?
i
Another answer, I changed all of the pads( front and rear) on my Element in about an hour. Obtained pads from Kragen auto parts store (about 70.00us) used floor jack and air gun. Simply unbolt wheels, caliper pins, slide out old pads, slide in new ones. I have been rebuilding brakes for 50 years, not all that hard.
