0
Honda Civic LX
The LX is a rebadged sixth-generation model of the Honda Civic. It was previously available only as a four-door car. It features 14-inch wheels, power locks and windows, front stabilizer bar, power steering, cruise control, cargo area light and a tachometer.
2,709 Questions
In automotive terms it would be what you would open to gain access to the engine compartment.
How do i fill the transmission fluid in a 2001 Honda Civic automatic?
You have to check in the actual transmission. Jack the car up (make sure it's level or you won't get an accurate reading) then take out the bolt on the back of the tranny and put your finger in it. It should be almost level with the hole, if not than add some. You can do this with a bucket of transmission fluid and a pump attached to hose...or, simply run a hose from the transmission fluid container to the transmission, hold the bottle above the car, so you'll need a long hose, and let gravity do the work. Once it starts to spill out a tiny bit, then you know your set and just put the bolt back.
How much does it typically cost to replace the starter on a 2001 Dodge Stratus?
i just had one replaced last week in a 96 model explorer, the starter was 160 and with labor it was about 250.00. or if you do it yourself you can get a good used starter or maybe a new starter off eBay for 50.00 maybe a little more or less, Jesse
What is the radio wiring color codes for a 1993 Honda Civic?
1995 And Newer Typical Nissan Pin What It Is In Dash Wire Color A Right Rear Speaker (+) Gray B Amplifier Turn On Wire C Right Rear Speaker (-) Gray w/ Red Stripe D Left Rear Speaker (+) Orange E Left Rear Speaker (-) Black w/ Pink Stripe F Amp Ground Wire (connect this wire to the radios ground wire) G +12 Volt Ignition Wire Blue H Do Not Use I Right Front Speaker (+) Brown J Left Front Speaker (+) Purple K Ground Wire (if available) metal brackets on radio L Do Not Use M +12 Volt Battery Wire Pink N Power Antenna Wire O Right Front Speaker (-) Brown w/ White Stripe P Left Front Speaker (-) Green w/ Yellow Stripe AS VIEWED FROM MATING END OF CONNECTOR a b g h i j c d e f k l m n o p
What is the spark plug gap for a 1992 Chevy V-6 with AC van?
It sould be on the iformation sticker on the fan shroud.
How do you get a radio code for 2008 Honda Pilot?
The radio's serial number is necessary when you contact Honda (800 number or local dealer) and request the code number to that particular radio. I don't own a Pilot but I've heard that some Honda radios will display the radio's serial number when you hold down buttons 1 and 6 simultaneously and turn it on.
How do you replace the alternator on a 1994 Honda Civic?
Here are some few more steps, in addition to the previously mentioned steps, that could help you in your repalcement:
1. Open the hood and locate your vehicle's alternator.
2. Using your digital multi-meter, check the battery voltage. A dead battery will usually have less than 9 volts. This would not be enough power to start most vehicles.
3. To verify that your alternator is bad, make sure your battery is fully charged and can pass a load test.
4. With the good battery installed, connect your digital multi-meter across the battery terminals with the engine turned off. A good battery should read between 12-13 volts.
5. Start your engine and read the digital multi-meter's output. The voltage should rise near 13.5-14.5 volts.
6. Using an open end wrench, disconnect the battery's negative cable
7. Disconnect the power and ground wires on the back of the alternator paying close attention to where each wire connects. Disconnect the wiring harness connector.
8. Loosen the alternator bracket bolts, and alternator adjusting bolts or alternator belt tensioner so that you can remove the alternator drive belt.
9. Using the proper size socket and ratchet, remove the alternator mounting bolts, spacer (if equipped), adjusting bolt, lower pivot bolt (if equipped), and the alternator.
10. Install new alternator.
11. Using the proper size socket and ratchet, loosely install the alternator mounting bolts, spacer (if equipped), adjusting bolt and lower pivot bolt (if equipped).
12. Install the alternator belt.
13. Pull the alternator until the alternator belt is tight.
14. Tighten the alternator mounting bolts while gently moving the alternator unit to achieve proper alternator belt tension.
15. Reinstall the power and ground wires to alternator. Install the wiring harness connector.
16. Push down in the middle of the alternator belt to check belt tension. If the alternator belt moves more than a half an inch, it is too loose, adjust the alternator belt to proper tension before proceeding to next step.
17. Now that the alternator belt has been installed and adjusted, reconnect the negative battery cable. Start the engine and check the battery voltage to verify proper alternator charging.
18. Turn off the engine and recheck the alternator belt tension. Readjust the alternator belt tension if needed.
Disconnect the battery. Then unplug the alternator and take the belts off. Unbolt it. Put a new one back on. Bolt it in. Put belts back on. Plug it back in. Reconnect the battery. Viola! Replaced alternator.
How to replace an alternator in a 1997 Honda civic?
you must lift up the civic with the driver side tire off then u gotta get the axle loose u might need to remove the whole left side suspention to free up the axle then u gotta get the alternator loose and remove it and then reverse.
/ The alternator can be removed by lifting front of car and driver side suspention lowered so that tire is just touching, then the alternator will have clearance to slide by driver side axle from under vehicle without removing any suspention. My son and I just did this so it should work on yours. (Aug 21, 2008)
Do you need a front license plate in the state of Oklahoma?
Yes. 4503.21 Display of license plates and validation stickers or temporary license placard or windshield sticker.(A) No person who is the owner or operator of a motor vehicle shall fail to display in plain view on the front and rear of the motor vehicle the distinctive number and registration mark, including any county identification sticker and any validation sticker issued under sections 4503.19 and 4503.191 of the Revised Code, furnished by the director of public safety, except that a manufacturer of motor vehicles or dealer therein, the holder of an in transit permit, and the owner or operator of a motorcycle, motorized bicycle, manufactured home, mobile home, trailer, or semitrailer shall display on the rear only. A motor vehicle that is issued two license plates shall display the validation sticker only on the rear license plate, except that a commercial tractor that does not receive an apportioned license plate under the international registration plan shall display the validation sticker on the front of the commercial tractor. An apportioned vehicle receiving an apportioned license plate under the international registration plan shall display the license plate only on the front of a commercial tractor and on the rear of all other vehicles. All license plates shall be securely fastened so as not to swing, and shall not be covered by any material that obstructs their visibility.
No person to whom a temporary license placard or windshield sticker has been issued for the use of a motor vehicle under section 4503.182 of the Revised Code, and no operator of that motor vehicle, shall fail to display the temporary license placard in plain view from the rear of the vehicle either in the rear window or on an external rear surface of the motor vehicle, or fail to display the windshield sticker in plain view on the rear window of the motor vehicle. No temporary license placard or windshield sticker shall be covered by any material that obstructs its visibility.
(B) Whoever violates this section is guilty of a minor misdemeanor.
Effective Date: 01-01-2004
What were some of the early tools to aid in measurement?
Weights and measures were among the earliest tools invented by man. Primitive societies needed rudimentary measures for many tasks: constructing dwellings of an appropriate size and shape, fashioning clothing and bartering food or raw materials.
What do you call the thing that you weight on?
One that will fit and not fall or crawl off and whose mass is within the limits of the balance. You could weigh a bottle of chemicals or a piece of metal, but if you tried weighing your puppy it would get off before you were done.
What colour are license plates from Canada?
The new ones mainly have a white background but different color lettering and borders depending on the province.
What does the re-stricter plate look like?
the restrictor plate is usually located inside of either the exhaust pipe, or manifold. it will typically look like an inset washer, and is used to restrict air flow from the header and to create backpressure on the engine, thus impeeding performance.
Where can you find a 1994 Honda civic vacuum schematic?
Autozone has Vacuum diagrams online in their repair manual section
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152800618ea
Why does a 98 Volvo s70 blow the fan motor fuse?
If there is nothing else on the circuit it's a good indicator that the fan motor is failing and probably has worn bearings. Worn bearings will cause an electric motor to pull more current and often blow a fuse. ==Additional Input== The purpose of a fuse it to protect the wiring circuit which it serves from excess current flow, which could severely damage the circuit conductors [wires], OR WORSE, CAUSE A FIRE!!! When a fuse "blows," or burns out, it indicates that there was an OVERLOAD on that circuit, and it did it's job by opening up the circuit. A blown fuse should NOT BE replaced, UNTIL someone has troubleshot the circuit, identified the cause of the overload, and corrected the defect. There are three most probable causes for fuse fuse failure: [1] A short circuit between the "hot" supply wire and ground [bare or cut wire in contact with a bare and sharp metal edge], [2] A defective fuse [which is highly unlikely] [3] Something which causes a "drag" on the blower motor which causes it to draw more current[amps], so much extra, that it excedes the current [amps] rating of the fuse. When the fuse is unable to carry the excess current, it fails by blowing. There are many things which could cause the drag: [1] As described by the previous answer, worn bearings would slow the motor and fan rotation, or [2] A buildup of trash [leaves, candy wrappers, etc.] in the plenum chamber around and in contact with the squirrel cage blower blades]. There may be another, or two, causes I can't think of right now. To fix this problem, you must determine what is causing the excess current demand, and remove/correct the defect. This could include: [1] Repair of wiring involved in a short circuit, [2] Clean out of debris blocking/dragging the fan, [3] Or as a last resort, replacement of the fan motor itself. Hope this helps you to understand and correct the problem. Good luck.
How many years does a timing belt last before it should be replaced this is 1998 Grand Cherokee?
Most manufacturers recommend replacing the timing belt every 70,000 miles.
What kind of motor comes in a 2000 Honda Civic?
The 1996-2000 Honda Civic came with the 1.6-liter SOHC 4-cylinder 16-valve engine.
What type of Transmission fluid should be used in a 2002 Honda Civic?
I would recommend genuine Honda ATF from the dealer, if not i use dexron III as a temporary substitute.
What cars can be flat towed behind a motor home?
Manual Transmissions and Automatic Transmissions with hydraulic pumps that work when the wheels are spinning.
Can a Saturn VUE be towed behind an RV on all 4's and what do you have to do to hook it up?
This is not a DIY job unless you have the proper tools. Severe injury can occur. Pay an expert to do it.
While removing the shock assembly from the coil spring is something that is dangerous and requires special tools and instructions. I just replaced all four struts on my 1999 Grand Prix with the Monroe Quick Strut. It comes fully assembled and it's just a matter of removing the wheels and a few bolts and putting the new ones in. Pretty straightforward for a DIY'er with some simple hand tools.
What is the little switch in the center console of a 1993 Honda Del Sol?
I know that on a 1994 Honda del sol the switch is wired to the fan relay, so anytime you felt the car was running to hot, you had to engage the fan. hope it helps.
