0
Isuzu Amigo
The Amigo is a rebadged three-door variant of the Wizard, a compact sports utility vehicle initially manufactured by Isuzu Motors in 1989. It was dropped in the US market in 1994, but made a comeback in 1998.
205 Questions
Replaced thermostat but cold air and still over heats?
Coolant at proper level?
System air bound and needs to be purged?
Water pump not circulating coolant?
Defective thermostat?
Collapsed radiator hose?
How do you change the thermostat on a 1999 Isuzu amigo?
It's inside the intake. Mess of a job. 6hrs labor per book. Sfbnj@com cast.net
How do you replace the tail lights on a 1999 Isuzu amigo?
it`s very easy to do this, first you need a screwdriver to only 3 screws located in the stripes sides in the rear tail lights there are 2 off them you need unscrew those and finally the only screw left are located betwen the tail light and the rear bumper rigth in the midle are a litle hide, but iff you look in thah place i told you see it, and once you unscrew all, you need to aply a ligth force to the back to separate the tail light, and once you do this you can see the conectors off the bulbs you can put away onli aply a little turn. i hope my explanation can serve to you.
How do you repair a blown head gasket?
The intake manifold and exhaust manifold must be removed. Then the head must be removed and the gasket replaced. The head must be checked for cracks and to see if it is warped. Then it is all put back together.
Where is the camshaft position sensor on a 2000 Isuzu Amigo 4 cylinder?
IAW the Mitchell shop manual, the CPS is located top front of the engine between the camshafts. The plastic covered wire going into the sparkplug cover probably goes to it. (may need to remove the top cam belt cover to see it---not real sure as I haven't been into it yet. As I understand, the CPS regulates the fuel to the engine. As I have one that is defective/dirty/out of adjustment, the tailpipe is sooty to the touch.
How do you remove the distributor rotor on a 1989 Isuzu amigo?
There are 3 screws holding the distributor cap on. After removing the cap, there is a small Phillips head set screw holding the rotor in place on the shaft portion of the rotor.
Where is the fuel pump relay located on an Isuzu amigo?
under the hood on the passenger side of the motor bay. in the black fuse box.
Where are the spark plugs on a 1998 Isuzu amigo 4-cylinder 2.2L?
Directly on top of the motor. You need an Allen wrench to remove the black plastic panel from the top of the motor. Once you remove this cover, all (4) spark plugs are exposed. Note: You may have to move the air intake by unscrewing the air intake from the throttle body and and (1) bolt located between the fire wall and the air intake at the top.
Where is a 1993Isuzu amigo 2.6L coolant temperature sensor located?
The coolant temperature sensor that controls ECU cold start fuel enrichment and ignition timing is located behind the power steering pump on the bottom of the intake manifold right behind the thermostat housing.
Where is the coolant temperature sensor located on a 1998 Isuzu Amigo 2.2L engine?
The coolant temperature sensor is located under the hood of the car. The sensor is located to the left of the brake booster at the rear of the engine.Ê
How do you replace the headlight bulb located on a 1999 Isuzu Amigo?
Pop Hood. Remove black retaining ring that holds light bulb socket in the light housing. This requires turning the ring and then pulling the socket out. Exchange bulbs and replace as removed. .
Where can i find a vacuum diagram for a 1998 Isuzu amigo?
A vacuum diagram for a 1998 Isuzu Amigo can be found in the maintenance and repair manual of the car. These can be found at any store selling car parts.Ê
Where is the ECU located on 1998 Isuzu Amigo?
For the 2.2 liter engine it's located between the fire wall and the engine near the top.
What should you do about a blown head gasket in your 1996 Saturn?
a blown head gasket needs to be replaced as early as possable. it will only get worse and additives like water glass, etc will gradually worsen the problem.
Description of the characters in amigo brothers?
the characters in amigo brothers are felix vargas and antonio cruz. they are both seventeen and puerto-rican. they live in new york. Antonio is fair, lean ,and lanky. his lean form makes him the better boxer. Felix is dark, short, and husky. his short and muscular form makes him the better slugger. they are both very passionte, athletic, loyal, competitive, and determined.
How do you replace a speed sensor on a Isuzu Rodeo?
the sensor is in the back of the rear differintial u need to check the wires running back by the right rear tire for breaks as this problem was apparent on my own 1993 rodeo other than that the sensor unplugs from the harness and is very easy to remove and replace
Why does the engine surge up and down on a 1993 Isuzu amigo?
Mine was doing the same thing at it was because the engine was overheating. Check for coolent leeks or the water pump may be bad.
