answersLogoWhite

0

Isuzu Rodeo

The Rodeo was a pickup truck manufactured by Isuzu from 1988 to 2002. Available as a two-door pickup truck, a two-door Spacecab pickup truck, and a four-door Crewcab pickup truck, the car features a front-engine, rear/four-wheel drive layout.

1,386 Questions

Why will my 1997 Isuzu Rodeos battery not charge?

Order of likelihood: 1. Alternator 2. Voltage regulator (probably built into the alternator 3. Battery 4. Wiring and/or connections in charging system. Visit a major chain auto parts dealer and they will diagnose the problem free of charge,. If you need and buy a new battery, they will install it at no additioal charge.

Will 24 inch wheels fit a 2000 Isuzu rodeo?

Larger 24 inch wheels will fit on a 2000 Isuzu rodeo. The tires will have to be a lower profile to keep the suspension untouched, but bigger ties will call for a raised suspension.

How do you change the dashboard lights in a 1996 Isuzu?

I own a 1997 Isuzu Rodeo and had the same problem. I went to a local Isuzu new-car dealer and was quoted a price in excess of $100 to replace the burned-out dashboard lights. I was told that the cost is high because the top of the dashboard has to be removed in order to obtain access to the lights. I did not have the lights replaced. carlpers

What is that diesel sound coming from your gas 3.2V6 Isuzu Rodeo engine?

== == == == Low octane fuel will cause this. Run a tank of high octane (PREMIUM) through it or add a bottle of octane boost in a full tank and it should go away. I have a 95.5 Honda Passport with 3.2 V6. I tried the higher octane method and to no help to my problem. switched to mobil 1 synthetic 5w/20 as recommended by everyone who has had this problem- has helped some- still a low tap sound (apparently this is an inherited problem with this engine- the oil return ports are too small and if the gather any trash/gunk- can become clogged and cause the tapping sound- I do an engine oil flush with every oil change). I will be replacing my timing belt later this week- its been stated that the sound could be timing belt slapping. engine is strong- runs good- have 211,000 miles on it- the tap started about 160,000 miles. It think its way overdue for that timing belt. updated a week later: replaced timing belt (bando brand- factory OEM part) (note- timing belt was worn - considerable amount of slack in belt= hence belt slapping the belt cover and causing a ticking sound) and all related components including water pump and tensioner replaced. I did oil change (Mobile 1 5w20 synthetic) including flush - replaced spark plugs and plug wires (note: used the bosch ultima plugs on last tune up- reduced performance- reduced gas milage considerably- gone back to standard NGK platinum plugs). tap noise is eliminated- engine is running smooth- far better performance and fuel economy noticed in first 500 miles. Before, I averaged about 360 miles per full tank- now I am getting about 420 miles per full tank of fuel. Note: good timing belt replacement information and possible tapping noise in valve train solution found at http://forum.planetisuzoo.com/viewtopic.php?t=13189

How do you change the tail light bulb in a 2001 Isuzu Rodeo?

Three Phillips head screws hold on the entire assy. There are two on the side and one on the bottom. You may need a flashlight to see them because they are recessed and black. To see the one at the bottom you look between the bumper and the bottom of the light assy. Once the screws are removed just pull straight out to release the rubber grommets.

Could you please tell you On a 1998 Isuzu rodeo 3.2l v6 where does the cam shaft sensor connect to?

a two prong female wire connector coming from the left side wiring harness at the top of the motor. one of the two wires is orange.

How do you disarm the 1994 rodeo Isuzu security system?

This is nothing more than a spam site that will grab your browser until you log off... Not worth the trouble.

How do you change the fuel filter on a Isuzu Rodeo?

Fuel filter is on frame rail next to the fuel tank. Undo clamps and change, pointing the arrow in the flow direction. If you have the spring type clamps then it's a good time to put screw type on. The manual says to disconnect the battery first for safety.

How do you remove rotors on a Isuzu amigo?

For the rear, remove the tire and wheel. Remove the Brake Caliper and Brake pad bracket. Then the rotor should slide off the wheel studs. The front may have to have the spindle retaining nut and cotter pin removed once the brake pad bracket is removed. Be careful to not get dirt in the bearing.

Where is the ac low-pressure valve located in the engine compartment of a 1996 Isuzu Rodeo?

The AC low pressure valve on a 1996 Isuzu Rodeo is located in the back of the engine compartment. The valve is on the larger of the two hoses that run from the evaporator to the compressor.

What does 10.9 refer to on a metric bolt?

10.9 on a metric bolt indicates the hardness (or load, tensile strength, and hardness) of the bolt. This is almost as high as they get and is about the equivalent to a grade 8 SAE or USS bolt. 8.8 is also a common metric hardness.

How much should it cost to install a water pump and timing chain on a 1996 rodeo?

I was quoted $2200 to replace the timing belt for the amount of work and labor involved.

Where is the fuse for the power windows located on a 1995 Isuzu Rodeo because all four automatic windows quit working at the same time?

That circuit has a relay/circuit breaker not a fuse. Chances are you have a window motor with a dead short which is not allowing breaker to reset. Check the drivers side first; unplug it the window motor and see if the other windows come alive.

How do you add transmission fluid in an 1999 Isuzu Rodeo?

This is a very good answer below but it does NOT apply to a 1999 Isuzu Rodeo. The Rodeo's transmission is sealed, you cannot check fluid levels at home, you must take the vehicle to an authorized Isuzu mechanic so they can check the tranny fluid for you. Transmission: Keep an eye on your oil level, as it can get low on you real quick, especially on long hi speed highway trips. There are ways to remedy this. If equipped with an AT, your rodeo has a 4L30E GM trans. You should change the ATF. BMac- for the ATF leak thing, check the accumulator piston cover on the pass side of the trans. VERY common on the 4L30E. Leaks? How about the accumulator cover? It's on the right side and it's round. Check this: Accumulator repair: before trying to remove the snap ring you need to push the accumulator cover in then remove the cover don

How do you change the tail light on a 1989 thru 2002 Isuzu Rodeo or Honda Passport?

Shedding some lightYou actually have to remove the entire tailight assembly in order to replace the bulbs. You will need a medium lentgh Phillips (#2)screwdriver. There are three screws to remove, 2 on the side of the housing toward the front of the vehicle (inside the black plastic "brush guard") and one at the rear of the vehicle between the bumper and the trim piece under the tailight (you have to stick the screwdriver between the trim and the top of the bumper). Remove the 2 side screws first, then the bottom screw. Pull carefully from the rear of the vehicle and the tailight assembly should come straight off. Replace your bulb(s), them carefully set the bottom screw so that it will stay in place while you put the tailight back. Tighten bottom screw, but not snug, you want to leave it loose so you can line up all the guides. Replace the side screws, then tighten the bottom screw. The screw between the bumper and the trim faces the rear of the car - it is NOT the screw that faces the bottom of the vehicle.

On the 1989-1997 models remove the 4 lens screws from the backside and replace bulbs from front of housing.

What kind of oil does a 2004 rodeo take?

This truck takes synthetic 10w-40 oil i use castrol oil(synthetic blend)

What does Error 3 in a 2000 Izuzu Rodeo 6-disk CD changer mean?

I have the same problem, twice and last time they told me the cds were getting stuck because the CD's that were in there were "see-thru" (like those used to burn music from a computer) and that that was somehow causing the cds to get stuck, they had to get a new CD changer for me last time (of coarse then it was under warranty, now its not)

How can I fix the fuel gauge Isuzu rodeo 2000 after changing the fuel sending unit?

after u drop the tank and replace the fuel sending unit your gas gauge should start working correctly. try jcwhitney.com they seem to have the cheapest price on the unit and pump combo.