0
Isuzu Rodeo
The Rodeo was a pickup truck manufactured by Isuzu from 1988 to 2002. Available as a two-door pickup truck, a two-door Spacecab pickup truck, and a four-door Crewcab pickup truck, the car features a front-engine, rear/four-wheel drive layout.
1,386 Questions
How to fix error code P0401 on Honda Passport 2001?
EGR System, insufficient flow detected, maybe bad sensor? Your sensor is more than likely fine. It is probably the air intake to the EGR located in the throttle body. Take off the air intake cover and it is right behind the throttle plate. Just clean out the import to the EGR, because it gets clogged up and then the EGR isn't receiving the correct amount of air. Try that before you go spend the money on a pricey sensor.
What does a starter solenoid do?
solenoids mounted on the starter have 2 functions 1a magnetic coil pulls a plunger which pushes the small (Bendix) gear into the engines flywheel gear at the same time it completes the power circuit that feeds the starter motor and that turns the Bendix gear when the key is released a spring returns the Bendix a it disengages from the fly wheel
On almost all cars any sensor unplugged can turn on the check engine light.
Where is the hood release on a 1976 Chevy Nova?
There are two;first one under front bumper; then one between hood & top of Grill.
Why is the Check Engine light coming on and off on my 1998 Isuzu Rodeo?
The check engine light (service engine soon) comes on and stays on when a problem is detected by the self diagnosis system of your vehicle. Generally, the problem is in the emissions or something that is affecting the effectiveness of the emissions, but other causes can trigger the light to come on, too. To determine the cause, the vehicle will need to be taken to a parts store or a shop that has an OBD2 scanner, or for 1995 and earlier models, an OBD1 scanner, While a scanner will not give you the magic answer, it will give you a code that narrows down the problem area.
The check engine light (service engine soon) comes on and stays on when a problem is detected by the self diagnosis system of your vehicle. Generally, the problem is in the emissions or something that is affecting the effectiveness of the emissions, but other causes can trigger the light to come on, too. To determine the cause, the vehicle will need to be taken to a parts store or a shop that has an OBD2 scanner, or for 1995 and earlier models, an OBD1 scanner, While a scanner will not give you the magic answer, it will give you a code that narrows down the problem area.
Where are the spark plugs located for a 2002 Isuzu Rodeo v6?
There are 3 on each side of the engine. Once you take off the metal covers there will be a black rubber sleeve you will need to remove and they are down in there.
Where do you check the automatic transmission fluid on a 2002 Isuzu Rodeo?
The Transmission fill plug on these models is located on the bottom of the pan. There are 2 plugs located there. One is the drain plug and the other is to fill/check. The fluid should be high enough to slowly trickle out of the hole. This has to be checked while the engine is running and in gear. This is VERY DANGEROUS process. It is advisable to have your local shop do this for you. I had to change the fluid in one about 6 months ago and was very disappointed in the design. I would recommend having the dealer do this for the reason that they are familiar with the concept of how it is done. Most shops will not be able to accomplish this with accurate results. Again, This is a very dangerous due to the vehicle having to be running and in gear before and reading can be obtained. If not runnin it will be over full.
What kind of oil for 1996 Isuzu Rodeo?
what type of oil depends on how many miled are on the vehicle, my rodeo has 160xxx miles on it so i use 10w 30 High Milage With a qrt of Lucas Oil Treatment and it still runs great and gets great gas milage.
How do you change the front speakers on a 1995 Isuzu Rodeo?
The speaker covers are held in with a screw, remove it and tilt it out away from where the screw was. then remove the screws holding the speaker in and remove the speaker.
What would cause a 1999 Isuzu rodeo to stop running?
Some causes for a 1999 Isuzu Rodeo to stop running include a lack of fuel, a bad battery, or defective spark plugs. There can also be a combination of issues which would need to be diagnosed by a mechanic.
2001 Isuzu Rodeo why is it backfiring while turning ignition on?
Have you checked that the coil packs are all plugged in? Replace your spark plugs? Heck I would replace the plugs just to rule them out as the fault. I would need a little more information to answer this fully.
What is the transmission fluid for a 1998 Isuzu Rodeo?
I own a 1998(automatic) 3.2L V6 4x4 Rodeo,and I follow the service manual which says to use DEXRON II auto transmission fluid.
Where do you put the oil in a 1993 Isuzu Rodeo?
The oil in a 1993 Isuzu Rodeo is put into the reservoir that is located on top of the valve cover. There is a cap that has to be rotated to remove it.
Where is the Starter solenoid on a Peugeot 405?
Try to follow the + battery cable (if - ground) should connect to solenoid either at top of starter or at fender well
How do you replace lug nuts on a 1999 Isuzu Rodeo?
Pretty simple really just use a lug wrench ( there is one supplied with the vehicle ) and the appropriate key if it a security nut and remove it, then screw the new one on and tighten.
Where is the fuel filter located on a 2000 Isuzu Rodeo?
it is under the vehicle on the drivers (left) side approx. between the front and rear doors it is a small cannister 1/2 the size and shape of a beer can and will have a fuel hose on each end close to the rocker panel forward of the fuel tank
Its a cool site to show of your cars or anything tha goes fast with serious torque. I love the app...
How do you replace the fuel filter located on a 1994 Isuzu Rodeo?
The main fuel filter is located under the vehicle. On the drivers side about mid-point. It is mounted on the frame of the car. It is held in place with a strap mounted to the frame. It is a small cylinder with two hoses on either end. A single bolt holds the fuel filter to the frame. loosen this bolt first. Then there is a fuel hose/line on either end of the filter , uncalmp these hoses using a set of pliers, then remove the hoses from either end of the filter. Warning!!!!! There is lot of pressure in these fuel lines the gasoline tends to spill everywhere watch your face and eyes and be prepared to crimp or plug the fuel lines as soon as they are off the filter as fuel will continue to flow frely once the hoses are removed. Remove filter from tensioner strap. Replace with new filter observing the directional arrows stamped or painted onto the new filter, to insure proper directional flow of fuel to motor. Re-attach the fuel lines, and re-clamp tightly. Note: consider replacing fuel hose/line if the line seems worn or degraded as well as using "worm" clamps as opposed to OEM for tighter more snug clamp. To make this repair safer, always DEpressurize fuel lines. First you remove the fuel pump fuse (on my '92 Rodeo, it's in the black box on the passenger fender)- then start the engine and run to use gas out of lines. You may still get a little fuel dribble, but no spraying gas all over. After replacing filter, replace fuel pump fuse and turn key on a few seconds for fuel pump to refill lines. Then crank engine and check for leaks around fuel filter connections.
Transmission not shifting into third gear or overdrive?
check fluid level, if good, will need pro evaluation
Where is the temperature sensor on a 1995 Isuzu Rodeo?
on the themostat housing where the upper rad hose meets the intake manifold
