0
Isuzu Rodeo
The Rodeo was a pickup truck manufactured by Isuzu from 1988 to 2002. Available as a two-door pickup truck, a two-door Spacecab pickup truck, and a four-door Crewcab pickup truck, the car features a front-engine, rear/four-wheel drive layout.
1,386 Questions
How do you se the clock on a 1996 Isuzu Rodeo?
The Stereo unit model 8200 in an 1996 Isuzu Rodeo has in the upper right hand corner a small button "Disp". While holing that button down with the stereo OFF, use the "TRACK" selection buttons in the lower left of the center display to select (left button) HOURS, (Right Button) Minutes. NOTE: THere is no designation for PM/Am
check fluid level
How do you release fuel pressure?
Locate and pull the fuse for the fuel pump. Crank the engine for 5-10 seconds. No more fuel pressure.
How do you get the hood open to fix the hood release cable on a Toyota Tercel?
Uh...I inserted my key in hood release mechanism to hold it open (like you would pull it with your hand) and then went up to the front of the car and pulled the hood free and then released it...That worked for me, hope it helps you too.
Where is the front wiper relay located in a 2000 s-10 blazer?
from my experience it is under the brake fluid reservoir
What is the cost to replace a tie rod end in Isuzu rodeo?
The estimated cost to replace one inner tie rod end on a 2003 Isuzu Rodeo is between $121 and $227 including parts and labor. The estimated cost to replace one outer tie rod end is $118 to $205.
How do you align the timing marks on a Holden rodeo 2.6?
When you are trying to align the timing marks on a Holden Rodeo 2.6, just get the crank and cam marks aligned, no need to worry about the others. Make sure the belt is tight on the right side between the cam and crank sprockets when they are on their marks. After that simply apply the tensioner.
How do you disable the alarm that won't turn off for 1999 Honda passport or izusu rodeo?
The alarm will go off if the keyless entry has quit working. the keyless entry and alarm module is behind the glove box in the right corner. There is no way to bypass this module. The dealership will charge you out the ass for a new one. But back to the point, the key will disable the alarm. When the alarm goes off when you unlock the driver or passenger door, lock the driver door and unlock it again with the key. It should go off the first time you unlock it, but if it doesn't, lock it and unlock it again. This should disable the alarm. Atleast it does on my Rodeo.
How much should a valve cover gasket job cost for a 1994 Isuzu rodeo My mechanic said about 600.00?
a '''valve cover gasket''' is not a $600.00 job it takes about 30mins tops. you could do that your self and save the cash. the valve cover is that piece that is on top of the engine, in some vehicles is the piece that has the "hole" from where you put oil in to the engine. 6 bolts tops.
now, if he meant a '''head gasket'' then yes it could be $600.00 or more.
On my 93 rodeo I had the valve cover gasket changed and it cost me $500.00. It was the labor that costs so much. The mechanic had to take a lot of stuff off that was around the gasket cover to get to and remove the cover. You may want to ask your mechanic how much of that $600 is labor costs.
You will need to tell the kind of car or truck, year of production and engine size. All are located in different places.
1991 Isuzu pickup with 3.1
Isuzu rodeo automatic transmission?
I have acquired an Isuzu Rodeo 2000 4x2 model with a v6 3.2L and it only had 50,000 miles! The day after I got it the Automatic transmission died on me. i had it rebuilt and it only lasted 2 months! My mechanic suggested I go on line and find a new/used one...but have recently read on-line that the best bet is to rebuild and dump it! Is that a real suggestion...I love the car and the ride...need help? Suggestions please
1) Insert tab 1 into slot 1.
2) Toggle the on/off switch rapidly.
3) Locate the noise production valve and pump firmly and slowly.
4) Making sure that you have a 3 qt. pan to catch the fluids and remove plug from drain (Caution is advised as the fluids may be hot and scalding may occur. Safety goggles and ear plugs are recommended).
5) Cash check.
How many oxygen sensors are on a 1993 Isuzu Rodeo or Trooper V6 3.2?
It appears that the 1993 Isuzu 3.2L V6 engine has just one oxygen sensor. It's a 4-wire type, located at the exhaust Y-pipe outlet. == ==
How do you replace the thermostat on a 2000 Isuzu rodeo 3.2 engine?
I looked at my 2000 3.2L and the thermostat housing is under the plenum or manifold. The Haynes Manual pic shows the housing on the front of the engine as a easy fix. THE HAYNES MANUAL IS WRONG.
In addition to draining the coolant, you will have to take off the Air Cleaner, fuel injectors, all connecting hoses and cables (the ones pinched up against the firewall are a mutha), and the 8-10 bolts holding down the manifold before you can even see the T-housing bolts.
Now if you are a really good mechanic (I'm not but have seen this done) you can leave most of the aforemention parts attached, take out the manifold bolts, pry up the housing up and hold it with a 2x4. Stick you hand in there, using the brail method to find/remove the 4 housing bolts and remove the housing and thermostat. Instalation is just as fun.
Where is the camshaft sensor located on a 2000 Isuzu Rodeo?
for the four cylinder it is located in the front part of the engine. you have to remove the spark plug cover cap, then remove the serpentine belt. remove the timing belt cover, then remove the timing belt cover mounting screw located in between the two gears. for the 6 cylinder it is on the back of the drivers side head just behind the intake manifold screwed in from the outside 10mm bolt
What causes check engine light to come on on a 97 Isuzu rodeo?
Lots of problems could cause the light to come on. First off, check your fluid levels; second, take it to a mechanic.
I had the same problem and soon discovered that I was out of transmission fluid. The way I discovered this of course was the stream of fluid I left right before this happened. I looked beneath the vehicle to find the entire underside covered in transmission fluid, and discored it had been leaking from the Accumulator Piston Cover on the front passenger side of the transmission housing. It is a small round black plastic circle with an indentation in the center which you can see clearly if you cut your wheels to the left and look behind the passenger side front tire at the transmission housing. I ordered a new cover from my local Isuzu service center, $23.00 and some change shipping and part, and you use a snap ring tool, inner type, to remove the old one and snap the new one in place. Then you can use 3/8 inch outer diameter tubing with a funnel held high and pour the transmission fluid into the fill hole on the bottom of the tranny pan until it runs out of the overfill hole up top. Then start the motor and let it get to idle temp, and the tranny fluid will start to circulate and you can continue filling the tranny. According to Oreilly's Auto Parts a fresh fill takes 9 quarts of Dexron III ATF.
What happens to the two brothers who are captured by the utes?
They win their freedom by impressing the Ute chief and doing a difficult deed.
Isuzu rodeo heat up but get cold when driving?
change you thermostat it is stuck open or not closing fully. This allows the coolant to circulate to quickly.
Where is the location of oil drain plug on BMW 318i?
To change oil: With the engine warm, unscrew the oil drain plug (19 mm wrench)
AT THE BOTTOM RIGHT OF THE SUMP.
The Sump is the Very Bottom of the oil pan- The Deep part.
(where all the "crap" collects).
! =)
