Isuzu

Most of the Isuzu npr trucks holds 6 and a half quarts of transmission oil.

Take the dipstick out ues a funnel and put it in through the dipstick hole!

As with all inline four cylinders, The firing order is 1342.

On a 1997 Isuzu Rodeo, the oil filter is located on the bottom front of the motor beneath the fan.

valve clearance for Isuzu 4ba1 engine is 17.00.

Torque settings:

Phase 1. 29ft/lb or 39 Newton Meter

2. 54 73

3. 72 98

Have vehicle scanned to see if any codes are stored

Never heard of nor have I seen an Oxygen Sensor light. If you are referring to the Check Engine Light, then that light comes on when there is a problem with the emissions controls. It may be a bad O2 Sensor or it may be many other things. Don't assume the O2 sensor is bad. Depending on the year vehicle you own, which you failed to mention, you reset the light on most 1995 & older vehicles by disconnecting the battery for 5 minutes. On most 1996 & newer vehicle, you reset the light with an OBD2 scan tool.

0.025mm straight

the firing order will be 1342 or 1243

It is located between the camshafts right behind the camshaft pulley's.

on a 1989 Isuzu pickup with a 2.6 same engine

12 degree b.t.d.c. at 900 rpm

0.40mm for both inlet and exhust when cold on 4jb1, 4jh1 engines

Should be the same

The ASR dash light is a brake assist system/acceleration slip regulation light. When this light comes on in the Isuzu NPR truck, the on board computer in the vehicle detected a malfunction in the acceleration slip regulation and the vehicle needs to be taken for service.

How I can replace ignition switch cylinder from Isuzu Rodeo?.

The knock sesor is located, on your Isuzu 1290, at the front of the engine. The sensor screws into the engine. Wires connect the sensor to the senor light.

16 thousandths of inch

In the center of your dash board the Where the radio is

If the finish on the pressure plate looks rough, burned as in discolored, scratched or gouged in any way do yourself a favor and just replace it. Most shops worth anything won't turn them anymore anyway. The price of the new one is only around sixty dollars or less depending on where you get it. Be sure to check your tranny oil and replace the drive shaft seals as well they don't cost that much and when you're done your done. Good luck.

radio 1990 isuzu pickup

Track is the dimension from the centerline of the tire tread on one tire to the centerline of the tire tread on the opposite tire on the same end of the vehicle, front track or rear track. Wheelbase is the dimension from the centerline of the front tire to the centerline of the rear tire.

I believe, you have to remove the caliper and bracket. Then remove the axle nut. All the bearings will come off. A very messy project. They are not just knock off rotors like most cars.

try this. while holding pressure on the key towards start, turn the wheel to the left and then to the right in short motions but as far as you can. if the steering column is locked then the key wont turn because of pressure being put against the locking cam. if this does not work then you are probably going to have to replace the ignition.

Wiper motor is not working properly or the combination switch in the steering column is not working properly which is the lever that turns the wipers on.