Machinery and Tools

The SJ nut turns to the left to loosen

Yes

Bloomer, Wisconsin

the same as a piece of string silly?

no, not unless you're doing some 'extreme sports' version of jumping rope. mild exercise and activity are not a threat to the fetus, and will tend to make the mother feel better during pregnancy. Just follow common sense: don't overdo it, stop it you feel any pain or discomfort, and try not to trip and fall.

The one with the 'grippiest' or biggest handle. -I have one with a handle the size and shape of a tennis ball, it turns hard screws very easily,because I can get a better grip.

Yes. Its all hydrogen and carbon. Reduce it until it is the heat range you want it to be.

You will find that if done properly it is safe and adds value to your waste oil by giving it more btu's per gallon. Do not burn it without reduction!

It's a drill bit with a very sharp point for drilling hardwood without splintering it.

it works by having the bucket tied to the rope on a pulley system that you lower done into the well and then the bucket fills up and after this you pull the rope and the bucket of water will come up full

Every proper wrench will tighten or loosen bolts. -If this is a riddle or joke, please enter it in that category.

There is no part of a screwdriver called 'the wheel'.

barbed wire

Surprisingly enough- a 6 mm drill bit, or if you don't have one,1/4 drill bit will do.

When I was 2 years old, in 1948, my family moved into an old home in Plymouth, Michigan. It had a coal burning furnace that heated water for our steam radiators.

The furnace needed to be stoked with coal and a water valve had to be opened to fill the water tank every day in the winter. In 1949 or 1950 my father had the furnace converted to oil, so we no longer had to shovel coal. However, we still had to fill the water tank manually. Our furnace conversion occurred in the late 1940's or early 1950's. I hope this answers your question. Doug Balfour

A Torx wrench is a different kind of wrench for special Torx screws. Same principle as Allen or Bristol wrench. Torx is designed so you can get more torque on the screw.

The dangers of using a hand saw are basically being careful not to cut your own hand that may be holding whatever you are cutting.

It's a very short wrench head that fits on a ratchet driver instead of a socket.

They tell you if things are horizontal or vertical.

a ratchet

First, unplug the gun from your airline to avoid any accidents. Now remove the front cap of the gun (with a 1/8 allen wrench, I believe on this model) and you will see the jammed nail. Use a small screwdriver or prybar to remove it and then push the piston up. Now screw back the plate and carry on nailing.

a machine in which the drilling head is mounted to slide along a radial arm which can be rotated, raised, or lowered on a vertical mast to adjust the position of the drill above the workpiece Often shortened to radial.

Thermostat calls for heat. Induced draft fan motor starts. Vent pressure switch verifies pressure. Simultaneously gas valve opens and ignitor lights burner(ignition varies: hot surface ignitor, electronic spark ignitor, or standing pilot). Flame is sensed. High limit temperature switch is made. Blower fan runs. Thermostat calls for no heat. Gas valves close. Burners shut off. Induced draft fan shuts off. Blower fan put into fan delay(fan blower continues to run). Low limit temperature switch made. Fan blower stops.

Looking down , you turn clockwise to tighten and the other way to loosen. This is common world wide.

Clamp your work to the drill table, keep your hands, clothing and hair away from rotating parts, tighten the chuck firmly , when stopping, do not touch the tool till it is totally stopped.

There are many sizes of drilling machine. the smallest is possibly the Dremel drill and they go all the way up through handheld electric drills to floor drill presses taller than people.