0
Mercury Villager
The Villager was a minivan manufactured by Ford Motor Company from 1993 to 2002, and was a rebadged version of the Nissan Quest. Designed by Moray Callum, the Villager featured a five-speed automatic transmission and a front engine, front-wheel drive layout.
1,605 Questions
Yes !! There are bushings at the lever pivot and the shift collar. These should be checked and replaced at the dealer or a competent repair shop.
How do you install external tank heater on a mercury villager?
I would not recommend that you try. A block heater is preferred.
What is the correct spark plug gap for a 1993 mercury villager 3.0 liter?
According to fordparts.com the spark plug gap is ( .032 inch ) on a 1993
Mercury Villager with the 3.0 liter V6
How do you remove the spare tire on 1997 mercury villager?
Use the tire wrench to turn the screw under the carpet in the cargo area to lower it. Consult your owner's manual.
Where is the diagnostic machine port in a 1996 mercury villager?
Under the dash to the right of the steering column.
What sign will a 2002 mercury villager make when the oil pump bad?
None, oil pumps are not prone to wear out or fail. If the oil pump is actually failing the whole engine is probably worn.
Why does your 1994 Mercury Villager overheat with a new thermostat?
Either the thermostat was not the problem, or you put it in backwards.
This is a mildy interesting question. However, it is very easy to answer. Conventional brakes are brakes that a car uses in order to slow down or stop. Conventional brakes are simply just called brakes.
Where is the EEC-IV Diagnostic connector located on a 95 Mercury Voyager?
The diagnostic connector is located beside the starter. On your car it should be a four pin connector with three wires in it. More important than the location is what to do with it after you find it. For that you should have a repair manual, as the procedure gets quite involved.
What is the e-at button for on dash?
On my 1995 Mercury Villager the button in question (labled Power EAT in my van) alters the shift points to higher speed settings for more power to help out with situations like towing a heavier trailer. EAT simply stands for Electronic Automatic Transmission; the labeling has always been somewhat of a mystery. The best explanation is that the transmission is electronically controlled for shifting rather than the old speed vacuum control methods and this switch allows for easy reprogramming of the shift points to avoid constant up - down shifts that would result from the standard economy oriented settings.
Why does your mercury villager check engine light flash 20 times?
Its trying to give you a trouble code to tell you whats wrong with the car. Take it to someone who has a code reader, such as an autoparts store or oilcan Henry's if you have one near you.
How do you remove the inner arms on the rear passenger seats in a 2000 Ford Windstar?
I don't know if this will work but its worth a try. Rotate the armrest up and down to locate the pivot point of the armrest. After locating the pivot point try pushing the armrest toward the seat very firmly. While pushing inward try rotating the armrest past the up or down stop. If you can get past that stop a little further rotation should bring it to a point where the arm rest will release and be able to be pulled away from the seat. Good luck. This method has worked on other seats but I don't know if it will work on a Windstar seat.
From everything that I have read about this, the engine mounting and the amount of room that the engine requires, the engine will fit in. However on saying that it was also stated that while the engine will fit, the electronics that go with the ecotec will not. Therefore, while the engine replacement will not be exceptionally hard you will have to go through all of the electrical to make sure that everything in your car still works.
Why would the windshield wipers only work when the right turn signal is on on a Mercury Villager?
You probably have shorted wires inside the combo switch. The assembly will need to be replaced.
Spark plug gap on 1997 mercury villager?
On all Ford and Mercury cars I have worked on the gap was on the tag under the hood. The year and engine size is on the tag keep looking on it and the gap should be on there. Most fords are .52 to .56 gap.
==========================================================
According to the 1997 Mercury Villager Owner Guide and one of the Ford websites
The spark plugs for the 3.0 liter V6 engine are gapped at
( .034 inch )
Where is the fuel pump reset switch on a 2002 mercury mountaineer?
Type your answer here... It should be located on passenger side kick panel.
Water pump location on a 1987 3.0 mercury villager engine?
There is no such thing as a 1987 Villager, I assume you mean a '97. The water pump is in the center of the engine in front, behind and above the crank pulley. To remove it requires that the crank pulley be removed, which may require special tools.
Where is the speedometer fuse for a 2000 mercury villager?
The speedometer is part of the instrument cluster, and is fused with the other instruments.
How do you change a fuel pump on a 1994 mercury villager?
The fuel pump is located in the tank, and the tank must be removed to access it.
What causes a 1996 mercury villager odb codes p1400 p0135 p0325?
P1400 Differential Pressure Feedback EGR Circuit Low Input (Dealer TSB Number: 99103 addressed some possibles with this issue)
p0135 Heater O2 Sensor1 Bank 1 (This is the first sensor nearest the engine)
P0325 Knock Sensor
The last code often sets with almost any other problem, there is probably nothing wrong with the knock sensor itself, it's a passive part.
The O2 sensor may be bad, but it may also have a broken wire about six inches up the harness where there is a splice, this is a COMMON problem on these vehicles.
The P1400 I would not worry about until you get the O2 sensor problem fixed. These codes tend to daisy-chain on these vehicles, sometimes one problem will cause 3 codes, I've seen it many times.
What is the fuel tank capacity of a 2001 Mercury Villager?
20 gallons.
http://consumerguideauto.howstuffworks.com/2001-mercury-villager-3.htm
a simple Google search yields amazing results!
How do I find Error code 1997 Mercury Villager?
Error codes on a 1997 Mercury Villager can be found by connecting an OBDII code reader to the diagnostic port. The service manual has a full list of error codes and their causes.
Why my sliding door on 95 mercury villager want stay open for children to get out?
if you look on the bottom track there is a little rubber bump in it. On your van it must be almost flat. it is supposed to poke up like an upside down V.
Mine has the same problem and although I have tried to get it to stick up again, it may have to go to a mechanic who can replace the rubber bump.
http://KevinsCamera.com
